1 upvotes, 1 direct replies (showing 1)
View submission: HELP! P1S Filament Cutter problem.
Reset the entire printer to factory. Reset bambu studio to factory. Try again. Redo the calibration. Confirn to yourself that you Change nothing.
If it persists after a complete factory Reset, put in a ticket to bambu.
Comment by PopularStu at 15/06/2024 at 02:17 UTC
1 upvotes, 1 direct replies
Thank you for the idea. It was factory when I took it out of the box, and I'm not sure a factory reset would fix it.
It seems to be a hardware fault... (I posted a separate video about it)
But I did send off a support request.
So I will wait and see.
Thank you