NICE(2)                                                                 Linux Programmer's Manual                                                                NICE(2)

NAME
       nice - change process priority

SYNOPSIS
       #include <unistd.h>

       int nice(int inc);

   Feature Test Macro Requirements for glibc (see feature_test_macros(7)):

       nice():
           _XOPEN_SOURCE
               || /* Since glibc 2.19: */ _DEFAULT_SOURCE
               || /* Glibc <= 2.19: */ _BSD_SOURCE || _SVID_SOURCE

DESCRIPTION
       nice() adds inc to the nice value for the calling thread.  (A higher nice value means a lower priority.)

       The range of the nice value is +19 (low priority) to -20 (high priority).  Attempts to set a nice value outside the range are clamped to the range.

       Traditionally,  only a privileged process could lower the nice value (i.e., set a higher priority).  However, since Linux 2.6.12, an unprivileged process can de‐
       crease the nice value of a target process that has a suitable RLIMIT_NICE soft limit; see getrlimit(2) for details.

RETURN VALUE
       On success, the new nice value is returned (but see NOTES below).  On error, -1 is returned, and errno is set to indicate the error.

       A successful call can legitimately return -1.  To detect an error, set errno to 0 before the call, and check whether it is nonzero after nice() returns -1.

ERRORS
       EPERM  The calling process attempted to increase its priority by supplying a negative inc but has insufficient privileges.  Under Linux, the  CAP_SYS_NICE  capa‐
              bility is required.  (But see the discussion of the RLIMIT_NICE resource limit in setrlimit(2).)

CONFORMING TO
       POSIX.1-2001, POSIX.1-2008, SVr4, 4.3BSD.  However, the raw system call and (g)libc (earlier than glibc 2.2.4) return value is nonstandard, see below.

NOTES
       For further details on the nice value, see sched(7).

       Note: the addition of the "autogroup" feature in Linux 2.6.38 means that the nice value no longer has its traditional effect in many circumstances.  For details,
       see sched(7).

   C library/kernel differences
       POSIX.1 specifies that nice() should return the new nice value.  However, the raw Linux system call returns 0 on success.  Likewise, the nice() wrapper  function
       provided in glibc 2.2.3 and earlier returns 0 on success.

       Since glibc 2.2.4, the nice() wrapper function provided by glibc provides conformance to POSIX.1 by calling getpriority(2) to obtain the new nice value, which is
       then returned to the caller.

SEE ALSO
       nice(1), renice(1), fork(2), getpriority(2), getrlimit(2), setpriority(2), capabilities(7), sched(7)

Linux                                                                          2021-03-22                                                                        NICE(2)