SEAGATE TECHNOLOGY, INC. Customer Technical Support FAX Network +1 408 438-8137 Customer Technical Support Bulletin Boards (300-9600, 8-N-1) ��������������������������������������������������������������������Ŀ � United States +1 408 438-8771 � United Kingdom +44 628 478011 � ��������������������������������������������������������������������Ĵ � Germany +49 89 140-9331 � Singapore +65 227-2217 � ���������������������������������������������������������������������� (C)opyright 1993 ST-3610N SCSI-2 Fast �����������ͻ � REAR VIEW � �����������ͼ 50 pin I/O Cable Connection � J1�������������������������1� /���������\ TOP (HDA) ͵:::::::::::::::::::::::::�ͳ 0 0 0 0 ��� �������������������������; ��5�G�G�12� BOTTOM 1�����Ŀ 1�����Ŀ 1�����Ŀ �������� �������� �������� �Terminating Resistors� �����������������ͻ � RIGHT SIDE VIEW � �����������������ͼ BACK �͸ J2 12345678 TOP (HDA) FRONT OF J1�����������������������P�W�A����������������������� OF DRIVE �; :::::::: BOTTOM DRIVE �������� �Terminator Power ٳ������ Reserved ڴTerminator Power �ٳ����� Start Delay (12 secs * ID) � Factory Use ��ٳ���� Motor Start � Parity Enable �������� Write Protect � � � ��������������������������������Ŀ �Ĵ Termination Power-source Table � ����������������������������������������������Ŀ ������....�����....�����PWA edge����� � � � � 1 2 1 2 1 2 � � �ķ �ķ A Drive Supplies Bus � � ���� ���� ����� B Drive Supplies Own � � ���� ���� �� �� C Bus Supplies Drive � � A B C � ����������Default������������������������������� ����������������ͻ � LEFT SIDE VIEW � ����������������ͼ If these ID jumpers are used, then ID jumpers shown in front view ARE NOT USED. FRONT TOP (HDA) J5 ���1� �͸BACK OF ��������P�W�A������������������������������͵:::�͵J1 OF DRIVE BOTTOM ���; �;DRIVE ��� ID 4 �ٳ�� ID 1 ID 2 ������������ͻ � FRONT VIEW � ������������ͼ TOP (HDA) J6 ������1� ��P�W�A�������������������������͵::::::�� * BOTTOM ������; � 123456 LED �� ������ ID 4 ٳ���� Reserved ID 2 �ٳ��� Remote LED (pin-3 +5v) ID 1 ������ Spindle Synchronization (pin-6 REF SIG+) If these ID jumper are used, then ID jumpers shown in left side view ARE NOT USED. ST-3610N UNFORMATTED CAPACITY (MB) ________________635 FORMATTED CAPACITY (xx SECTORS) (MB) _____535 AVERAGE SECTORS PER TRACK ________________79 rounded down ACTUATOR TYPE ____________________________ROTARY VOICE COIL TRACKS ___________________________________13,104 CYLINDERS __PHYSICAL______________________1,872 (user) HEADS ______PHYSICAL______________________7 DISCS (3.5 in) ___________________________4 MEDIA TYPE _______________________________THIN FILM RECORDING METHOD _________________________ZBR RLL (1,7) INTERNAL TRANSFER RATE (mbits/sec)________25 to 41 EXTERNAL TRANSFER RATE (mbyte/sec) _______4 Async EXTERNAL TRANSFER RATE (mbyte/sec) _______10 Sync SPINDLE SPEED (RPM) ______________________5,411 AVERAGE LATENCY (mSEC) ___________________5.54 BUFFER ___________________________________256 KByte Read Look-Ahead, Adaptive, Multi-Segmented Cache INTERFACE ________________________________SCSI-2 FAST BYTES PER TRACK (unformatted) ____________48,460 average SECTORS PER DRIVE ________________________1,046,205 TPI (TRACKS PER INCH) ____________________ AVERAGE ACCESS (ms) (read/write)__________10.5/11.2 Drive level without controller overhead SINGLE TRACK SEEK (ms) ___________________2 MAX FULL SEEK (ms) _______________________24 MTBF (power-on hours) ____________________200,000 POWER REQUIREMENTS: +12V START-UP (amps) _1.5 +12V TYPICAL (amps) __0.4 +5V START-UP (amps) __ +5V TYPICAL (amps) ___0.6 TYPICAL (watts) ______6.5 MAXIMUM (watts) ______ WRITE PRECOMP (cyl) ______________________N/A REDUCED WRITE CURRENT (cyl) ______________N/A LANDING ZONE (cyl) _______________________AUTO PARK IBM AT DRIVE TYPE ________________________0 or NONE Physical: Height (inches/mm): 1.00/25.4 Width (inches/mm): 4.02/102.1 Depth (inches/mm): 5.77/146.6 Weight (lbs/kg): 1.5/0.68 Already low-level formatted at the factory with one spare sector per track and two spare cylinders/unit. ZBR = Zone Bit Recording = Variable sectors per track Seagate reserves the right to change, without notice, product offerings or specifications. (08/08/94)