SEAGATE TECHNOLOGY, INC. Customer Technical Support FAX Network +1 408 438-8137 Customer Technical Support Bulletin Boards (300-9600, 8-N-1) ��������������������������������������������������������������������Ŀ � United States +1 408 438-8771 � United Kingdom +44 628 478011 � ��������������������������������������������������������������������Ĵ � Germany +49 89 140-9331 � Singapore +65 227-2217 � ���������������������������������������������������������������������� (C)opyright 1993 ST-3620N SCSI-2 Fast (Hawk 1LP) �����������ͻ � REAR VIEW � (ST-3620N only) �����������ͼ 50 pin I/O Cable Connection � J1�������������������������1� /���������\ TOP (HDA) ͵:::::::::::::::::::::::::�ͳ 0 0 0 0 ��� �������������������������; ��5�G�G�12� BOTTOM �����������ͻ � REAR VIEW � (ST-3620NC only) �����������ͼ 80 pin I/O and DC Power Wall/bracket Connection � J1 /���ij���������������\ TOP (HDA) ����������/ �������������������� \���������� (\�1������������������40/) BOTTOM Notes on 80 pin I/O connector: pins 1 - 4 = +12v 41 - 44 = 12v GND 34 - 36 = +5v 74 - 76 = 5v GND 37 = SYNC 77 = LEDC 38 = MTRON 78 = DLYDST 39 = SCSIA0 79 = SCSIA1 40 = SCSIA2 80 = SCSIA3 Mating NC connector: AMP US p/n: 2-557103-1 straight-in 2-557101-1 right angle to PCB �����������������ͻ � RIGHT SIDE VIEW � (Both ST-3620N and ST-3620NC) �����������������ͼ BACK �͸ J2 12345678 TOP (HDA) FRONT OF J1�����������������������P�W�A����������������������� OF DRIVE �; :::::::: BOTTOM DRIVE �������� �Terminator Power ٳ������ Reserved ڴTerminator Power �ٳ����� Start Delay (12 secs * ID) � Enable T-Res ��ٳ���� Motor Start � Parity Enable �������� Write Protect � � � ��������������������������������Ŀ �Ĵ Termination Power-source Table � ����������������������������������������������Ŀ ������....�����....�����PWA edge����� � � � � 1 2 1 2 1 2 � � �ķ �ķ A Drive Supplies Bus � � ���� ���� ����� B Drive Supplies Own � � ���� ���� �� �� C Bus Supplies Drive � � A B C � ����������Default������������������������������� ����������������ͻ � LEFT SIDE VIEW � (ST-3620N only) ����������������ͼ If these ID jumpers are used, then ID jumpers shown in front view ARE NOT USED. FRONT TOP (HDA) J5 ���1� �͸BACK OF ��������P�W�A������������������������������͵:::�͵J1 OF DRIVE BOTTOM ���; �;DRIVE ��� ID 1 �ٳ�� ID 4 ID 2 ������������ͻ � FRONT VIEW � (Both ST-3620N and ST-3620NC) ������������ͼ TOP (HDA) J6 ������1� ��P�W�A�������������������������͵::::::�� * BOTTOM ������; � 123456 LED �� ������ ID 4 ٳ���� Reserved ID 2 �ٳ��� Remote LED (pin-3 +5v) ID 1 ������ Spindle Synchronization (pin-6 REF SIG+) If these ID jumper are used, then ID jumpers shown in left side view J5 or 80 pin I/O cable ARE NOT USED. ST-3620N Hawk 1LP UNFORMATTED CAPACITY (MB) ________________651.8 FORMATTED CAPACITY (xx SECTORS) (MB) _____545.9 AVERAGE SECTORS PER TRACK ________________78 rounded down ACTUATOR TYPE ____________________________ROTARY VOICE COIL TRACKS ___________________________________13,500 CYLINDERS __PHYSICAL______________________2,700 user HEADS ______PHYSICAL______________________5 DISCS (3.5 in) ___________________________3 MEDIA TYPE _______________________________THIN FILM RECORDING METHOD _________________________ZBR RLL (1,7) INTERNAL TRANSFER RATE (mbits/sec)________24.4 to 42.4 EXTERNAL TRANSFER RATE (mbyte/sec) _______4 Async EXTERNAL TRANSFER RATE (mbyte/sec) _______10 Sync SPINDLE SPEED (RPM) ______________________5411 AVERAGE LATENCY (mSEC) ___________________5.54 BUFFER ___________________________________256/1024 KByte Read Look-Ahead, Adaptive, Multi-Segmented Cache INTERFACE ________________________________SCSI-2 FAST SECTORS PER DRIVE ________________________ TPI (TRACKS PER INCH) ____________________3000 AVERAGE ACCESS (ms) (read/write)__________9.3/10.5 Drive level without controller overhead SINGLE TRACK SEEK (ms) (read/write)_______1.0/1.7 MAX FULL SEEK (ms) (read/write)___________19.4/22.9 MTBF (power-on hours) ____________________500,000 POWER REQUIREMENTS: +12V START-UP (amps) _1.5 +12V TYPICAL (amps) __0.5 +5V START-UP (amps) __ +5V TYPICAL (amps) ___0.2 TYPICAL (watts) ______7 MAXIMUM (watts) ______ WRITE PRECOMP (cyl) ______________________N/A REDUCED WRITE CURRENT (cyl) ______________N/A LANDING ZONE (cyl) _______________________AUTO PARK IBM AT DRIVE TYPE ________________________0 or NONE Physical: Height (inches/mm): 1.00/25.4 Width (inches/mm): 4.02/102.1 Depth (inches/mm): 5.77/146.6 Weight (lbs/kg): 1.5/0.68 Already low-level formatted at the factory with one spare sector per track and two spare cylinders/unit. ZBR = Zone Bit Recording = Variable sectors per track Seagate reserves the right to change, without notice, product offerings or specifications. (08/09/94)