SEAGATE TECHNOLOGY, INC. Customer Technical Support FAX Network +1 408 438-8137 Customer Technical Support Bulletin Boards (300-9600, 8-N-1) ��������������������������������������������������������������������Ŀ � United States +1 408 438-8771 � United Kingdom +44 628 478011 � ��������������������������������������������������������������������Ĵ � Germany +49 89 140-9331 � Singapore +65 227-2217 � ���������������������������������������������������������������������� (C)opyright 1991 ST-1481N SCSI-2 Fast �����������ͻ � REAR VIEW � �����������ͼ 50 pin I/O Cable Connection �������������������������1� J4�:::::::::::::::::::::::::� /���������\ ����P�W�A�������������������ͳ 0 0 0 0 ��� �������1 �������1 �������1 ��5�G�G�12� �������� �������� �������� �Terminating Resistors� ����������������ͻ � LEFT SIDE VIEW � ����������������ͼ 12345678 ��������͸ FRONT J6�::::::::� BACK OF �����������1��������������P�W�A�������������������������� OF DRIVE �������� DRIVE Factory Use ٳ������ Terminator Power (see below)� Motor Start �ٳ����� Terminator Power (see below)��Ŀ Start Delay ��ٳ���� Reserved � Write Protect �������� Parity ��������������������������������Ŀ � Termination Power-source Table � �����������������������������������������Ŀ � 7 8 7 8 7 8 � � �ķ �ķ ���ķ A Drive Supplies Own � � ���� ���� ����� B Drive Supplies Bus � � ���� ���� � � C Bus Supplies Drive � � A B C � �������������P�W�A�����������������������; �����������������ͻ � RIGHT SIDE VIEW � �����������������ͼ ���1� BACK J5�:::� FRONT OF �������������P�W�A��������������������������������������� OF DRIVE ��� DRIVE ID 4 �ٳ�� ID 1 If these ID jumpers are used, ID 2 then ID jumpers shown in front view ARE NOT USED. ������������ͻ � FRONT VIEW � ������������ͼ If these ID jumper are used, �����͸ then ID jumpers shown in right side J7�:::::� view ARE NOT USED. ���1������������P�W�A��������������������� ����� ID 1 ٳ��� Remote LED ID 2 �ٳ�� Spindle Synchronization ID 4 ST - 1481N UNFORMATTED CAPACITY (MB) ________________492 FORMATTED CAPACITY (xx SECTORS) (MB) _____426 AVERAGE SECTORS PER TRACK ________________62 ACTUATOR TYPE ____________________________VOICE COIL TRACKS ___________________________________13,302 CYLINDERS ________________________________1,476 HEADS ____________________________________9 DISCS (3.5 in) ___________________________5 MEDIA TYPE _______________________________THIN FILM RECORDING METHOD _________________________ZBR RLL (1,7) INTERNAL TRANSFER RATE (mbits/sec) _______17 to 25 SPINDLE SPEED (RPM) ______________________4,412 AVERAGE LATENCY (mSEC) ___________________6.8 BUFFER ___________________________________256 Kbyte Read Look-Ahead, Adaptive, Multi-Segmented Cache INTERFACE ________________________________SCSI-2 Fast SECTORS PER DRIVE ________________________823,608 TPI (TRACKS PER INCH) ____________________1760 BPI (BITS PER INCH) ______________________ AVERAGE ACCESS (ms) ______________________14 SINGLE TRACK SEEK (ms) ___________________2.5 MAX FULL SEEK (ms) _______________________26 MTBF (power-on hours) ____________________150,000 POWER REQUIREMENTS: +12V START-UP (amps) _2.5 +12V TYPICAL (amps) __0.54 +5V TYPICAL (amps) ___0.53/0.8(ND) TYPICAL (watts) ______9/11.0(ND) MAXIMUM (watts) ______15 WRITE PRECOMP (cyl) ______________________N/A REDUCED WRITE CURRENT (cyl) ______________N/A LANDING ZONE (cyl)________________________AUTO PARK IBM AT DRIVE TYPE ________________________0 or NONE Already low-level formatted at the factory. ZBR = Zone Bit Recording = Variable sectors per track Seagate reserves the right to change, without notice, product offerings or specifications. (4/12/91)