💾 Archived View for bbs.geminispace.org › s › FreeBSD › 6170 captured on 2024-07-09 at 02:09:00. Gemini links have been rewritten to link to archived content
⬅️ Previous capture (2024-06-16)
-=-=-=-=-=-=-
My laptop is currently configured for a wired network (em0) and WIFI(wlan0). Relevant /etc/rc.conf:
ifconfig_em0="DHCP" wlans_iwm0="wlan0" ifconfig_wlan0="WPA DHCP"
When the system comes up, networking seems to work. However, bringing wlan0 down makes the system stop working. I just spent a few hours trying to figure out what's going on, and I managed to get it working but it seems too convoluted. What's a good way to do this?
When I bring down wlan0, netstat -r still shows (now stale) wlan0's default gateway, and needless to say, routing fails. /etc/resolv.conf likewise shows old name servers. To get the system to work from ethernet, I have to do the following manually:
sudo route delete default sudo service dhclient restart em0
similarly, when I unplug the ethernet and bring up wlan0, I have to reset the gateway, to match WIFI's expectations.
While this works, it is very cumbersome to say the least.
How do you deal with this?
2023-10-13 · 9 months ago
🚀 stack [OP] · 2023-10-13 at 05:31:
To answer my own question: yet again, vermaden has a solution, a shell script that solves all problems.
— https://forums.freebsd.org/threads/scripted-network-management-with-network-sh.62013/
At least I wasn't crazy, it is an issue.
🦀 jeang3nie · 2023-10-13 at 15:02:
This one is just a bit esoteric, but there is a solution. It's called link aggregation, or a lagg interface. What this means is that you combine two interfaces into one virtual interface, either for load balancing or failover if your primary interface becomes unavailable. You'd want the latter. It's covered in section 34.9 of the FreeBSD handbook under advanced networking. If you scroll down they give an example of setting this up for using a wired connection as your primary and wireless as the failover.
🚀 stack [OP] · 2023-10-13 at 17:10:
@jeang3nie, I will have a look, although my primary goal is to be able to easily switch between wired, several in-home wifis, and coffeehouse wifis, on my thinkpad.
🦀 jeang3nie · 2023-10-13 at 19:29:
You should be able to move between different wireless networks using wpa_supplicant. Not sure how that would fit into the scheme I mentioned earlier, because the docs don't mention it specifically.