๐พ Archived View for m0yng.uk โบ 2022 โบ 02 โบ GEEETech-i3-3d-printer captured on 2024-05-12 at 15:12:35. Gemini links have been rewritten to link to archived content
โฌ ๏ธ Previous capture (2024-05-10)
โก๏ธ Next capture (2024-07-08)
-=-=-=-=-=-=-
Created 2022-02-27
I'm currently babysitting a 3d printer, it's a "GEETech i3 Pro C" - apparently.
The end goal is to make the Penkesu Computer, but first I need to get the printer working as well as possible so I can print the case.
It's a fairly basic device from what I understand, manual bed levelling for example, but has a heated bed and two extruders. Aligning the nozzles for these to be exactly the same height off the bed is ... not fun.
After quite a few small burns (and one that really hurt and still hurt after 4 hours under water) I think I'm finally getting it dialled in to work well with both extruders simultaneously.
This is the latest "XYZ calibration cube" printed with extruder 0 (purple) for the perimeters, and extruder 1 (yellow) for the infill.
The slicer preview looks like this
A purple sided cube with yellow top. X and Y on the sides and Z on the top [IMG]
The resulting cube looks like this
Photos of all the sides are at the end of the page, if you care or want to help me improve the results!
I think I'm trying to do something quite hard here, use both extruders on every layer, but I really want to have my computer case have purple edges and yellow middle, because if I'm making it as a one off just for myself why shouldn't I have it look how I want? Other than that being hard.
To answer the inevitable "yeah, but can it even print with just one extruder anyway?" - Yes, it can. These two cubes were printed with exactly the same settings but using only one extruder, the purple loaded into extruder 0 and yellow into extruder 1. The only difference is that I grabbed a nearby fan to aid general cooling for the yellow cube as the purple one had droopy soft warm infill.
I'm using "PrusaSlicer" with the following changes to the default printer configuration - using "expert" mode because that is required to unlock multiple extruders.
I find these (nominally per print) settings essential too
Every side of the cube, if you like that sort of thing.
Base (opposite Z) of the cube, a star pattern is visible in yellow with some gaps and splodges [IMG]
Left (opposite Y) side in purple has lots of strings of extra purple [IMG]
-+--+--+--+--+--+--+--+--+--+--+--+--+--+--+--+-
๐ค Black Lives Matter
๐๐ค๐ Trans Rights are Human Rights
โค๏ธ๐งก๐๐๐๐ Love is Love
Copyright ยฉ 2024 Christopher M0YNG - It is forbidden to use any part of this site for crypto/NFT/AI related projects.
Code snippets are licenced under the Hippocratic License 3.0 (or later.)
Page generated 2024-03-24 by Complex 19