💾 Archived View for spam.works › mirrors › textfiles › computers › tec007.txt captured on 2024-02-05 at 11:28:30.
⬅️ Previous capture (2023-06-14)
-=-=-=-=-=-=-
STAC ELECTRONICS
TECHNICAL SUPPORT BULLETIN
NUMBER: 007
SUBJECT: SREMOVE; STACKER-MISC
DATE: May 24, 1991
TIME: 3:06 PM
SOURCE: Tech Support, User's Manual
SUPERCEDES/
SUPERCEDED BY:
RELEASE STATUS: Public
TITLE:
Removing a STACKER volume completely; down/upsizing a drive.
OVERVIEW:
STACKER's SREMOVE utility is used in the process of both permanently
removing a STACKER volume and "changing" the size of either the STACKER
volume or the uncompressed drive.
ISSUES/COMMENTS:
1) The permanent removal of a STACKER volume entails the removal of all
of the data inside of it.
2) At this time, it is not possible to increase the size of a STACKER
volume. It is necessary to remove the volume completely, then to create
another volume of a different size. This applies if the STACKER
volume is too small (too much space left uncompressed when the STACKER
volume was created). Stacker version 2.0 can reduce the size of the
Stacker drive using SDEFRAG /G (page 94 in the User Guide).
RECOMMENDED ACTIONS:
1) Permanent removal:
a) back up all data on STACKER volume;
b) run SREMOVE (see User's Manual, "STACKER Utilities--SREMOVE");
c) delete DEVICE=STACKER.COM... and DEVICE=SSWAP.COM.. lines in
CONFIG.SYS, per instructions following SREMOVE..
2) "Changing" the size of a STACKER volume:
a) proceed as for permanent removal;
b) make another free space STACKER volume using INSTALL or SCREATE,
and changing only the amount of space to leave uncompressed;
c) restore data to the new STACKER volume;
d) edit CONFIG.SYS for new STACVOL filename.