💾 Archived View for gemini.bortzmeyer.org › rfc-mirror › rfc3429.txt captured on 2023-12-28 at 18:13:09.
⬅️ Previous capture (2021-11-30)
-=-=-=-=-=-=-
Network Working Group H. Ohta
Request for Comments: 3429 NTT
Category: Informational November 2002
Assignment of the 'OAM Alert Label' for
Multiprotocol Label Switching Architecture (MPLS)
Operation and Maintenance (OAM) Functions
Status of this Memo
This memo provides information for the Internet community. It does
not specify an Internet standard of any kind. Distribution of this
memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (2002). All Rights Reserved.
Abstract
This document describes the assignment of one of the reserved label
values defined in RFC 3032 (MPLS label stack encoding) to the
'Operation and Maintenance (OAM) Alert Label' that is used by user-
plane Multiprotocol Label Switching Architecture (MPLS) OAM functions
for identification of MPLS OAM packets.
1. Introduction
This document describes the assignment of one of the reserved label
values defined in RFC 3032 (MPLS label stack encoding [2]) to the
'OAM Alert Label' that is used by user-plane MPLS OAM functions for
identification of MPLS OAM packets as described in the ITU-T
Recommendation Y.1711 [1] (on MPLS OAM functions).
2. OAM functions
MPLS OAM (Operation and Maintenance) functions provide necessary
tools for network operators to operate and maintain the networks.
MPLS OAM functionality is required at the MPLS layer, and more
specifically at each MPLS level, independent of OAM functionality
provided by the lower layers (SONET/SDH, etc.). The objectives of
the OAM functions include the following:
- Defect and failure detection: Defect/failures affecting the
transport of user information are detected by continuous or
periodic checking. As a result, maintenance event information or
appropriate alarms will be produced.
Ohta Informational [Page 1]
RFC 3429 OAM Alert Label for OAM Functions November 2002
- Reporting the defect/failure information: Defect information is
given to other management entities (e.g., Operation Support
System) in order to provide the appropriate indications to the
maintenance staff for maintaining the Quality of Service (QoS)
level offered to customers.
- Defect/failure localization: Determination by internal or external
test systems of a failed entity is performed if defect information
is insufficient.
- Performance monitoring: Performance (packet losses, transfer
delay, bit errors, etc.) of the user information transport is
measured in order to estimate the transport integrity.
3. OAM Packet Identification
The user-plane MPLS OAM mechanisms as described in the ITU-T
Recommendation Y.1711 [1] uses a special label called 'OAM Alert
Label' to differentiate OAM packets from the normal user packets.
One of the reserved label values defined in RFC 3032 (MPLS label
stack encoding [2]) is assigned to 'OAM Alert Label'. A value of 14
is used for this purpose.
4. MPLS OAM work in ITU-T SG13
ITU-T Study Group 13, Question 3/13 is progressing work on user-plane
MPLS OAM and has produced the following documents:
(1) Recommendation Y.1710 (Requirements for OAM functionality for
MPLS networks) [3]
(2) Corrigendum 1 to Recommendation Y.1710 [4]
(3) Recommendation Y.1711 (OAM mechanisms for MPLS networks) [1]
(4) Draft Recommendation Y.1720 (Protection switching for MPLS
networks) [6] relies on OAM mechanisms in Y.1711, under last call
as of Nov. 2002.
5. Considerations on penultimate hop popping (PHP)
In response to concerns raised during IETF meetings and in related
discussions, this section provides an explanation on how MPLS OAM
functions defined in ITU-T Recommendation Y.1711 [1] are applied to
MPLS networks where PHP is in effect.
Ohta Informational [Page 2]
RFC 3429 OAM Alert Label for OAM Functions November 2002
5.1 Scope of ITU-T Recommendation Y.1711
The scope of ITU-T Recommendation Y.1711 includes application to both
non-PHP and PHP cases as quoted below [1].
"1 Scope
This Recommendation provides mechanisms for user-plane OAM (Operation
and Maintenance) functionality in MPLS networks according to the
requirements and principles given in Recommendation Y.1710. OAM
functions specified in this Recommendation can be applied to both
non-PHP and PHP cases unless otherwise stated. The current version
of this recommendation is designed primarily to support
point-to-point and multipoint-to-point explicit routed LSPs
(ER-LSPs)."
5.2 Applicability of MPLS OAM to PHP
There are two cases where PHP is used:
Case 1: The ultimate node is an MPLS LSR, and implements both MPLS
control-plane and data-plane, but is not able to perform 2 lookups at
line rate. So it asks the penultimate node to pop the top label
(rather than swapping it), using the MPLS reserved label 3 (implicit
null label) as per defined in RFC 3032 [2].
Case 2: The ultimate node has no MPLS label look up and processing
capability and does not recognize labeled packets. This node asks
for PHP, using the MPLS reserved label 3 (implicit null label) as
defined in RFC 3032 [2].
Currently, MPLS OAM functions defined in ITU-T Recommendation Y.1711
[1] can only be applied to Case 1. The next subsection describes the
node behavior in Case 1. Application for Case 2 needs further study.
Also, application to carrier supporting carrier scenarios is for
future study.
5.3 Node behavior when OAM functions are activated
Where the ultimate LSR is an MPLS LSR and PHP is in effect, the
penultimate LSR pops the top label and forwards the OAM packet (with
the OAM label and the OAM payload intact) to the ultimate LSR [5].
- If the ultimate LSR supports MPLS OAM, it understands that a
received packet with an OAM label on top is an OAM packet, since
the original top label has been removed by the penultimate LSR.
It also knows the ingress LSR that originated the MPLS OAM packet
from the TTSI (Trail Termination Source Identifier) value of the
Ohta Informational [Page 3]
RFC 3429 OAM Alert Label for OAM Functions November 2002
received MPLS OAM packet. TTSI is a unique identifier for ingress
LSR that is contained in MPLS OAM packets (see ITU-T
Recommendation Y.1711 [1]).
- If the ultimate LSR does not support MPLS OAM, the OAM packet is
discarded as per section 3.18 of RFC 3031 [5].
6. IANA Considerations
The IANA has reserved the use of the MPLS label value of 14 as the
'OAM Alert Label'. See section 3 for additional information.
7. Security Considerations
This document does not raise any security issues that are not already
present in either the MPLS architecture or in the architecture of the
network layer protocol contained within the encapsulation.
OAM functions could enhance the security of MPLS networks. For
example, Connectivity Verification (CV) function defined in ITU-T
Recommendation Y.1711 [1] can detect mis-connections, and therefore
can prevent customers' traffic being exposed to other customers.
8. Acknowledgements
The author wishes to thank Shahram Davari with PMC-Sierra, Neil
Harrison with British Telecom, Monique Morrow, Thomas D. Nadeau, Hari
Rakotoranto and Chip Sharp with Cisco Systems, Khalid Ahmad and David
Allan with Nortel Networks, and Mina Azad with Azad-Mohtaj Consulting
for their valuable contributions and discussions.
9. Normative References
[1] ITU-T Recommendation Y.1711, "OAM mechanism for MPLS networks",
November 2002.
[2] Rosen, E., Tappan, D., Fedorkow, G., Rekhter, Y., Farinaccia, D.,
Li, T. and A. Conta, "MPLS label stack encoding", RFC 3032,
January 2001.
[3] ITU-T recommendation Y.1710, "Requirements for OAM functionality
for MPLS networks" July 2001.
[4] ITU-T Corrigendum 1 to Recommendation Y.1710, November 2002.
[5] Rosen, E., Viswanathan, A. and R. Callon, "Multiprotocol Label
Switching Architecture", RFC 3031, January 2001.
Ohta Informational [Page 4]
RFC 3429 OAM Alert Label for OAM Functions November 2002
10. Informative Reference
[6] ITU-T Draft Recommendation Y.1720, "Protection switching for MPLS
networks", under last call as of November 2002.
11. Author's Address
Hiroshi OHTA
NTT
3-9-11 Midori-Cho, Musashino-Shi
Tokyo 180-8585 Japan
Phone: +81 422 59 3617
Fax: +81 422 59 3787
EMail: ohta.hiroshi@lab.ntt.co.jp
Ohta Informational [Page 5]
RFC 3429 OAM Alert Label for OAM Functions November 2002
12. Full Copyright Statement
Copyright (C) The Internet Society (2002). All Rights Reserved.
This document and translations of it may be copied and furnished to
others, and derivative works that comment on or otherwise explain it
or assist in its implementation may be prepared, copied, published
and distributed, in whole or in part, without restriction of any
kind, provided that the above copyright notice and this paragraph are
included on all such copies and derivative works. However, this
document itself may not be modified in any way, such as by removing
the copyright notice or references to the Internet Society or other
Internet organizations, except as needed for the purpose of
developing Internet standards in which case the procedures for
copyrights defined in the Internet Standards process must be
followed, or as required to translate it into languages other than
English.
The limited permissions granted above are perpetual and will not be
revoked by the Internet Society or its successors or assigns.
This document and the information contained herein is provided on an
"AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Acknowledgement
Funding for the RFC Editor function is currently provided by the
Internet Society.
Ohta Informational [Page 6]