💾 Archived View for spam.works › mirrors › textfiles › hacking › techiq.txt captured on 2023-11-14 at 09:58:49.

View Raw

More Information

⬅️ Previous capture (2023-06-14)

-=-=-=-=-=-=-






 

 
1) CALLBACK UNITS:
 
Callback units are a good security device, But with most phone systems,
it is quite possible for the hacker to use the following steps to get
around a callback unit that uses the same phone line for both incomming 
and out going calls:First, he calls he callback unit and enters any 
authorized ID code (this is not hard to get,as you'll see in a moment).
After he enters this ID, the hacker holds the phone line open - he does 
not hang up. When the callback unit picks up the phone to call the user back,
the hacker is there, waiting to meet it.
 
 The ID code as I said, is simple for a hacker to obtain, because these 
codes are not meant to be security precautions.The callback unit itself 
provides security by keeping incomming calls from reaching the computer.
The ID codes are no more private than most telephone numbers. Some callback 
units refer to the codes as "location identification numbers," and some 
locations are used by several different people,so their IDs are fairly 
well known.I've been told that, in some cases,callback ubits also have 
certain simple codes that are always defined by default. Once the hacker 
has entered an ID code and the callback unit has picked up the phone to 
re-call him,the hacker may or may not decide to provide a dial tone to 
allow the unit to "think" it is calling the correct number. In any event,
the hacker will then turn on his computer, connect with the system - and 
away he goes.If the however, the hacker has trouble holding the line with 
method,he has an option: the intercept.
 
The Intercept: 
 Holding the line will only work with callback units that use the same 
phone lines to call in and to call out.Some callback units use different
incoming and outgoing lines, numbers 555-3820 through 555-3830 are dedicated 
to users' incoming calls, and lines 555-2020 through 555-2030 are dedicated 
to the computers outgoing calls.The only thing a hacker needs in order to 
get through to these systems is a computer and a little time - he doesn't 
even need an ID code. First,the hacker calls any one of the outgoing phone 
lines, which, of course, will not answer.Sooner or later, though, while the 
hacker has his computer waiting there, listening to the ring, an authorized 
user will call one of the incomming lines and request to be called back.
It will usually be less than an hours wait, but the hacker's computer 
is perfectly capable of waiting for days, if need be.
 
 The callback unit will take the code of the authorized user, hang up, 
verify the code, and pick up the phone line to call back.If the unit 
tries to call out on the line the hacker has dialed, the hacker has his 
computer play a tone that sounds just like a dial tone.The computer will 
then dial the number given that matches up with the user's authorized ID.
After that,the hacker can just connect his computer as he would in any 
other case.If he is really serious,he will even decode the touch tones 
that the mainframe dialed,figure out the phone number of the user the 
system was calling, call the person, and make a few strange noises that 
sound as though the computer called back but didnt work for some reason.
 
2) TRAPDOORS AS A POSSIBLILITY
 
 I haven't heard of this happening, but i think it is possible that a 
callback modem could have a trapdoor built into it.Callback modems are
run by software, which is written by programmers.An unscrupulous programmer 
could find it very easy to slip in an unpublicized routine, such as, 
"if code =*43*, then show all valid codes and phone numbers." And such a 
routine, of course, would leave security wide open to anyone who found the 
trapdoor.The obvious protection here, assuming the situation ever arises,
is simply an ethical manufactorer that checks its software thoroughly before 
releasing it.
 
 A trapdoor is a set of special instructions embedded in the large 
program that is the operating system of a computer.A permanent, 
hopefully secret "doorway", these special instructions enabe anyone who 
knows about them to bypass normal security procedures and to gain access to 
the computer's files.Although they may sound sinister, trapdoors were not 
invented by hackers, although existing ones are certainly used by hackers 
who find out about them.
 
3) THE DECOY
 
 One of the more sophisticated hacking tools is known as the decoy, and it 
comes in three versions.The first version requires that the hacker have an 
account on the system in question. As in my case,the hacker has a 
low-security account,and he tries this method to get higher-security 
account.He will first use his low-security account to write a program that 
will emulate the log-on procedures of the systems in questions. 
This program will do the following:
 

look as if the system is in charge.
 

 

 

 
The user will now assume that the account name or password was mistyped 
and will try again...this time (scince the real operating system is in 
control) with more success.You can see a diagram of the way these steps are 
accomplished
 
 ___________________   
 |   Clear Terminal   |
 |       screen       |
 |____________________|
           ||
  _________||_________
 |  Print Compuserve  |
 |      Computer      |
 |_____ Network ______|
           ||
  _________||_________
 |   Print "ENTER     |
 |     PASSWORD"      |______
 |____________________|      |
          ||                 |
 _________||_________        |
 |  PASSWORD ENTERED? |__NO__|
 |____________________|   
          ||_YES
 _________||_________
 |   SAVE PASSWORD    |
 |    INFORMATION     |
 |____________________|
          ||
 _________||_________
 |   PRINT "LOGIN     |
 |     INCORRECT      |
 |____________________|
          ||
 _________||_________
|   LOG OFF/RETURN   |
|    CONTROL TO      |
|  OPERATING SYSTEM  |
|____________________|
 
 4) CALL FORWARDING
 
 Many people use call forwarding by special arrangement with the phone 
company.When a customer requests call forwarding, the phone company uses 
its computer to forward all the customers incomeing calls to another 
number. Lets say, for example, that you want calls that come to your office 
phone to be forwarded to your home phone: A call from you to the phone 
company,some special settings in the phone companys computer, and all 
calls to your office will ring at your home instead.This little bit of help 
from the phone company is another tool used by hackers. Lets say you thought 
that the computer you were hacking into was being watched-because the 
sysop might have seen you and called the fed's and your sort of bugged by 
this nagging feeling that they will trace the next hacker that calls, 
just call the phone company and ask for call forwarding, pick a number, 
(ANY NUMBER) out of the phone book and have your calls forwarded to that 
number,Hea,Hea, the number you picked is the one that will be traced to,
not yours, so you could be hacking away,they think that they have traced you, 
but actually the number you had your calls forwarded too. they enter chat mode
and say (YOUR BUSTED!!!!, WE'VE TRACED YOUR PHONE NUMER THE FEDS ARE ON THE 
WAY!!), You could reply (Hea, SURE YA DID! I'D LIKE TO SEE YA TRY AND GET ME! 
GO AHEAD!) ,that wont seem very important to them at the time, but it will 
sure piss them off when they bust the wrong guy!  
 
5) RAPID FIRE
 
 Memory-location manipulation can be helpful, but there is another, more 
powerful,possibility, in some cases: the Rapid-fire method.To understand how 
this methos works, you have to know something about the way operationg 
systems work.When a user enters a command, the operating system first places 
the command in a holding area, a buffer, where it will sit for a few 
millionths of a second.The system looks at the command and say's "Does this 
person really have authorization to do this, or not?" Then, the command 
sits there a few thousandths of a second while the system runs off to 
check the user's authorization.When the system comes back to the command, 
it will have one of two possible answers: "OK, GO AHEAD," or "SORRY, 
GET PERMISSION FIRST."
 
 Once you are on a system that handles things this way, you can use the 
rapid-fire method to change the command while its sitting in the buffer,
waiting to be executed. If you can do this,you can do anything.You can enter 
a command that you know will be approved, such as "tell me the time." As soon 
as the system runs off to verify your right to know the time,you change 
the command in the buffer to something you know would not be approved-perhaps
"give me a list of all the passwords." When the system comes back with an 
"OK, go ahead," it responds to your second command, not the first. Of course,
this exchange has to be done very rapidly,but most systems existing today 
can be fooled by this trick. The question is,how easy is it to do, and how 
much authority do you need? I know of one system that let this one slip.
 
These are certainly not all the hacker's little secret tricks and tool's,
You will probably figure out some better, more efficiant,hacking techniques.
 
GOOD LUCK!!!!!!
L O G A N - 5
<------------------------------------------------>
 
?