💾 Archived View for spam.works › mirrors › textfiles › hacking › aio.box captured on 2023-11-14 at 09:47:52.
⬅️ Previous capture (2023-06-14)
-=-=-=-=-=-=-
===============================================================================
All In One Box
BY:
Disk Doctor
==============================================================================
Basicly, this should be common sense.. All You have to do is by a small
box (Preferable a rated box that will keep it from interfering with
that nice Raidio you carded last week <grin>)
If you want to be real cheap about it you can go with just a plywoord
box... But I highly suggest you use a PC case.. or something that will
not burn (Overloads?)
Then simply assemble that boxes discussed in this file.. Now after you
do that.. You're gonna have alot of boxes cluttering the old room. What
to do? Simple.. Getcha a powersupply.. And some switches (on/off) from
Raidio Shack (Yes pay for them.. They're not that expensive) Now.. if
you buy you a bread board. (Cards kits can be picked up anywhere. And
this is the type you should use) Then simply install the box on one of
these. And incase them in the PC case. Now.. You can drill a hole in
the case and run the line in there.. and likewise have another hole
drilled for the line to run back out (Phone that have a hook up for
more than one regular line can give you some of the parts)
Next install the cards.. You *MUST* Use a low voltage power supply
(These boxes don't need much if any.. And make sure that you check the
voltage in the circuit.. You can run it to a light bulb if you need
someplace to disperse some of it!
No the simple task.. Where the Disk Drives normaly go simply Hook you
up some on off switches.. So that you can easily switch between the
boxes.. This will make life SOOOOOO much easier... I promise..
Also if you want to make it easier with the phone lines you can aphro engineer
a line in. IE run the phone line in to box along the back with them being fully
exposed.. IE
-------------------------------
----------------------------------
This allows for a sort of switching system as it were. After this is done..
Simple solder wires where need and run them to the appropriate box.. you may
then hook a lever (Like you see in those old Frakenstein movies) to the box to
allow box priorty over the line..
All in all this is pretty simple shit. But just some ideas for you to play
with....
Later
Doc