💾 Archived View for spam.works › mirrors › textfiles › computers › 1006v-sr captured on 2023-11-14 at 09:07:45.
⬅️ Previous capture (2023-06-14)
-=-=-=-=-=-=-
?????????????????????????????????????????????????????????????????????????
? Western Digital Corp. WD1006V-SR1,SR2 ?
?????????????????????????????????????????????????????????????????????????
? ?
? J6 J3 J4 J5 J1(SR2) ?
? J1: Floppy ??????????????????????????????????????????????? ?
? J5: HD Control ?.... 1:::: 1:::: 1:::::: 1:::::: ?? ?
? J4: HD0 Data ? ?? ?
? J3: HD1 Data ? :::W1 ..W2 ?? ?
? J6: HD LED ? ..W3 ?? ?
? ? ..W4 ?? ?
? ? ?? ?
? ? ..W5 :W6 ?? ?
? ?????????????????? ?? ????? ?
? ??????????????????????? ? ?
? INTERFACE: ISA(AT)->ST412(RLL) ?
? CONTROLS: 2 Floppy Drives (SR2 only) (360KB, 720KB, 1.2MB, 1.44MB) ?
? 2 Hard Drives ?
? ?
? ?
? W1: 1-2: Hard Disk Mode: Latched Mode: OFF ?
? Non-Latched Mode: ON ?
? ?
? 3-4: Error Correction Code: *4-Byte ECC OFF ?
? 7-Byte ECC: ON ?
? ?
? 5-6: Onboard Cache: Cache Enabled: OFF ?
? Cache Disabled: ON ?
? ?
? W2: Onboard BIOS: BIOS Enabled: OFF ?
? BIOS Disabled: ON ?
? ?
? W3: Hard Drive I/O Address: *Primary Address: OFF ?
? Secondary Address: ON ?
? ?
? W4: Floppy Drive I/O Address: *Primary Address: OFF ?
? Secondary Address: ON ?
? ?
? W5: Dual Speed Floppy Support: Single Speed Drives: OFF ?
? Dual Speed Drives: ON (note 1) ?
? ?
? W6: Ground Connection: Bracket not connected to Board Ground: OFF ?
? Bracket connected to Board Ground: ON ?
? ?
? (note 1) DO NOT mix single & dual speed drives in the same system. ?
? ?
? (* defaults) ?
?????????????????????????? ADDITIONAL INFO ??????????????????????????????
? ?
? Low Level Format can be done on boards that have their BIOS enabled ?
? by utilizing the DOS DEBUG command g=cc00:5. ?
? ?
? It is recommended that a Format be accomplished when changing from a ?
? WD1003-XXX controller to the WD1006V type controller. ?
?????????????????????????????????????????????????????????????????????????