💾 Archived View for gemini.bortzmeyer.org › rfc-mirror › rfc1624.txt captured on 2023-11-04 at 14:42:43.
⬅️ Previous capture (2021-11-30)
-=-=-=-=-=-=-
Network Working Group A. Rijsinghani, Editor
Request for Comments: 1624 Digital Equipment Corporation
Updates: 1141 May 1994
Category: Informational
Computation of the Internet Checksum
via Incremental Update
Status of this Memo
This memo provides information for the Internet community. This memo
does not specify an Internet standard of any kind. Distribution of
this memo is unlimited.
Abstract
This memo describes an updated technique for incremental computation
of the standard Internet checksum. It updates the method described
in RFC 1141.
Table of Contents
1. Introduction .......................................... 1
2. Notation and Equations ................................ 2
3. Discussion ............................................ 2
4. Examples .............................................. 3
5. Checksum verification by end systems .................. 4
6. Historical Note ....................................... 4
7. Acknowledgments ....................................... 5
8. Security Considerations ............................... 5
9. Conclusions ........................................... 5
10. Author's Address ..................................... 5
11. References ........................................... 6
1. Introduction
Incremental checksum update is useful in speeding up several
types of operations routinely performed on IP packets, such as
TTL update, IP fragmentation, and source route update.
RFC 1071, on pages 4 and 5, describes a procedure to
incrementally update the standard Internet checksum. The
relevant discussion, though comprehensive, was not complete.
Therefore, RFC 1141 was published to replace this description
on Incremental Update. In particular, RFC 1141 provides a
more detailed exposure to the procedure described in RFC 1071.
However, it computes a result for certain cases that differs
Rijsinghani [Page 1]
RFC 1624 Incremental Internet Checksum May 1994
from the one obtained from scratch (one's complement of one's
complement sum of the original fields).
For the sake of completeness, this memo briefly highlights key
points from RFCs 1071 and 1141. Based on these discussions,
an updated procedure to incrementally compute the standard
Internet checksum is developed and presented.
2. Notation and Equations
Given the following notation:
HC - old checksum in header
C - one's complement sum of old header
HC' - new checksum in header
C' - one's complement sum of new header
m - old value of a 16-bit field
m' - new value of a 16-bit field
RFC 1071 states that C' is:
C' = C + (-m) + m' -- [Eqn. 1]
= C + (m' - m)
As RFC 1141 points out, the equation above is not useful for direct
use in incremental updates since C and C' do not refer to the actual
checksum stored in the header. In addition, it is pointed out that
RFC 1071 did not specify that all arithmetic must be performed using
one's complement arithmetic.
Finally, complementing the above equation to get the actual checksum,
RFC 1141 presents the following:
HC' = ~(C + (-m) + m')
= HC + (m - m')
= HC + m + ~m' -- [Eqn. 2]
3. Discussion
Although this equation appears to work, there are boundary conditions
under which it produces a result which differs from the one obtained
by checksum computation from scratch. This is due to the way zero is
handled in one's complement arithmetic.
In one's complement, there are two representations of zero: the all
zero and the all one bit values, often referred to as +0 and -0.
One's complement addition of non-zero inputs can produce -0 as a
result, but never +0. Since there is guaranteed to be at least one
Rijsinghani [Page 2]
RFC 1624 Incremental Internet Checksum May 1994
non-zero field in the IP header, and the checksum field in the
protocol header is the complement of the sum, the checksum field can
never contain ~(+0), which is -0 (0xFFFF). It can, however, contain
~(-0), which is +0 (0x0000).
RFC 1141 yields an updated header checksum of -0 when it should be
+0. This is because it assumed that one's complement has a
distributive property, which does not hold when the result is 0 (see
derivation of [Eqn. 2]).
The problem is avoided by not assuming this property. The correct
equation is given below:
HC' = ~(C + (-m) + m') -- [Eqn. 3]
= ~(~HC + ~m + m')
4. Examples
Consider an IP packet header in which a 16-bit field m = 0x5555
changes to m' = 0x3285. Also, the one's complement sum of all other
header octets is 0xCD7A.
Then the header checksum would be:
HC = ~(0xCD7A + 0x5555)
= ~0x22D0
= 0xDD2F
The new checksum via recomputation is:
HC' = ~(0xCD7A + 0x3285)
= ~0xFFFF
= 0x0000
Using [Eqn. 2], as specified in RFC 1141, the new checksum is
computed as:
HC' = HC + m + ~m'
= 0xDD2F + 0x5555 + ~0x3285
= 0xFFFF
which does not match that computed from scratch, and moreover can
never obtain for an IP header.
Rijsinghani [Page 3]
RFC 1624 Incremental Internet Checksum May 1994
Applying [Eqn. 3] to the example above, we get the correct result:
HC' = ~(C + (-m) + m')
= ~(0x22D0 + ~0x5555 + 0x3285)
= ~0xFFFF
= 0x0000
5. Checksum verification by end systems
If an end system verifies the checksum by including the checksum
field itself in the one's complement sum and then comparing the
result against -0, as recommended by RFC 1071, it does not matter if
an intermediate system generated a -0 instead of +0 due to the RFC
1141 property described here. In the example above:
0xCD7A + 0x3285 + 0xFFFF = 0xFFFF
0xCD7A + 0x3285 + 0x0000 = 0xFFFF
However, implementations exist which verify the checksum by computing
it and comparing against the header checksum field.
It is recommended that intermediate systems compute incremental
checksum using the method described in this document, and end systems
verify checksum as per the method described in RFC 1071.
The method in [Eqn. 3] is slightly more expensive than the one in RFC
1141. If this is a concern, the two additional instructions can be
eliminated by subtracting complements with borrow [see Sec. 7]. This
would result in the following equation:
HC' = HC - ~m - m' -- [Eqn. 4]
In the example shown above,
HC' = HC - ~m - m'
= 0xDD2F - ~0x5555 - 0x3285
= 0x0000
6. Historical Note
A historical aside: the fact that standard one's complement
arithmetic produces negative zero results is one of its main
drawbacks; it makes for difficulty in interpretation. In the CDC
6000 series computers [4], this problem was avoided by using
subtraction as the primitive in one's complement arithmetic (i.e.,
addition is subtraction of the complement).
Rijsinghani [Page 4]
RFC 1624 Incremental Internet Checksum May 1994
7. Acknowledgments
The contribution of the following individuals to the work that led to
this document is acknowledged:
Manu Kaycee - Ascom Timeplex, Incorporated
Paul Koning - Digital Equipment Corporation
Tracy Mallory - 3Com Corporation
Krishna Narayanaswamy - Digital Equipment Corporation
Atul Pandya - Digital Equipment Corporation
The failure condition was uncovered as a result of IP testing on a
product which implemented the RFC 1141 algorithm. It was analyzed,
and the updated algorithm devised. This algorithm was also verified
using simulation. It was also shown that the failure condition
disappears if the checksum verification is done as per RFC 1071.
8. Security Considerations
Security issues are not discussed in this memo.
9. Conclusions
It is recommended that either [Eqn. 3] or [Eqn. 4] be the
implementation technique used for incremental update of the standard
Internet checksum.
10. Author's Address
Anil Rijsinghani
Digital Equipment Corporation
550 King St
Littleton, MA 01460
Phone: (508) 486-6786
EMail: anil@levers.enet.dec.com
Rijsinghani [Page 5]
RFC 1624 Incremental Internet Checksum May 1994
11. References
[1] Postel, J., "Internet Protocol - DARPA Internet Program Protocol
Specification", STD 5, RFC 791, DARPA, September 1981.
[2] Braden, R., Borman, D., and C. Partridge, "Computing the Internet
Checksum", RFC 1071, ISI, Cray Research, BBN Laboratories,
September 1988.
[3] Mallory, T., and A. Kullberg, "Incremental Updating of the
Internet Checksum", RFC 1141, BBN Communications, January 1990.
[4] Thornton, J., "Design of a Computer -- the Control
Data 6600", Scott, Foresman and Company, 1970.
Rijsinghani [Page 6]