💾 Archived View for spam.works › mirrors › textfiles › fun › plane.txt captured on 2023-06-14 at 16:39:13.
-=-=-=-=-=-=-
1) Begin with a rectangular sheet of paper without holes, folds, or tears. Eight and one half inches on one set of sides by eleven inches on the other are recommended dimensions of the sheet of paper, but other sizes may be used. 2) Imagine a line with endpoints at the bisection of the shorter sides, and fold the paper in half at this line. Crease the fold and then open the paper so that it rests upon the fold, and the halves of the paper point upward in a `V' shape. Designate one of the short ends as forward and the other as rear. 3) Fold the right forward corner to the crease so that an isoscoles triangle is formed. The equal sides should be each one half the width of the paper, one running from the forward end of the crease until the right angle of the corner, which should also lay on the crease. The other equal side should run from the corner to the right edge of the paper, and should be perpendicular to the crease. 4) Repeat step 3 on the left side as if it were the mirror image of the right. You should now have a five sided shape resembling a triangle sitting on top of a rectangle. 5) Starting with the first point at forward, mentally designate each corner with a letter going clockwise A, B, C, D and E. Fold corner B down to the crease so that side AB follows the crease. Then fold corner E to the crease so that side EA is on the crease. 6) Fold the main crease back up so that the two sides match and cover each other. Make a fold on each side parallel to the crease and approximately one-fourth to one- third of the width from the crease to the side. These folds should point away from each other and should form a flat surface perpendicular to the main body. Optional: the following are steps that can be taken to `jazz up' your paper airplane, but are not essential to basic flight. 7) To give a longer, smoother flight, place a paper clip one or two inches from the forward tip. The clip should be placed over the crease. 8) For a more predictable and stable flight, place a short piece of scotch tape from one wing to the other. The tape should not exceed one and one half inches in length and should be placed approximately one third of the way from the rear to the front. 9) To make a tail, cut or carefully tear at the rear of the plane (one to two inches from the rear) starting from the crease straight to the wings being careful not to cut or tear the wings. Push the rear section that you have just separated up with your fingers until the section from the cut back sticks up from the wings in the opposing direction from the body. Other tips can be found in the Advanced How to Make a Paper Airplane by the author. X-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-X Another file downloaded from: The NIRVANAnet(tm) Seven & the Temple of the Screaming Electron Taipan Enigma 510/935-5845 Burn This Flag Zardoz 408/363-9766 realitycheck Poindexter Fortran 510/527-1662 Lies Unlimited Mick Freen 801/278-2699 The New Dork Sublime Biffnix 415/864-DORK The Shrine Rif Raf 206/794-6674 Planet Mirth Simon Jester 510/786-6560 "Raw Data for Raw Nerves" X-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-X