💾 Archived View for spam.works › mirrors › textfiles › virus › v101pt4 captured on 2023-06-16 at 21:05:07.
-=-=-=-=-=-=-
Portal-Rmail-To: garyt@cup.portal.com Received: by portal.com (3.2/Portal 8) id AA13204; Wed, 26 Apr 89 01:40:03 PDT Received: from Sun.COM (arpa-dev) by sun.Sun.COM (4.0/SMI-4.0) id AA18592; Tue, 25 Apr 89 23:09:17 PDT Received: from sun by Sun.COM (4.1/SMI-4.0) id AB12617; Tue, 25 Apr 89 23:09:07 PDT Message-Id: <8904260609.AB12617@Sun.COM> Received: from LEHIIBM1.BITNET by IBM1.CC.Lehigh.Edu (IBM VM SMTP R1.2) with BSMTP id 5947; Wed, 26 Apr 89 02:02:52 EDT Received: by LEHIIBM1 (Mailer R2.03A) id 5724; Wed, 26 Apr 89 02:02:48 EDT Date: Wed, 26 Apr 89 02:02:48 EDT From: Revised List Processor (1.5o) <LISTSERV@IBM1.CC.Lehigh.Edu> Subject: File: "V101 4" being sent to you To: "Gary F. Tom" <sun!portal!cup.portal.com!garyt> Date: Thu, 30 Mar 89 22:03 CST From: Gordon Meyer <TK0GRM1@NIU> Subject: Virus 101 chapter four Subject: Virus 101: Chapter 4 To: info-atari16@score.stanford.edu Having discussed the way viruses work, spread, and can be deterred, the only remaining topic is how to recognize when an attack occurrs. It is not always as simple, or as straightforward, as it may seem. What may appear to be a hardware problem may be a virus, and vice-versa. There is no absolute way to determine if a given symptom is being caused by a program error, a hardware error, a virus, or something else. Not all viruses cause destructive attacks, but those that do are usually devastating. When files start vanishing or becoming unreadable, it may be due to any of several reasons. Poor media, or abuse of media is not uncommon. A dirty disk drive head, or one drifting out of alignment can cause previously reliable disks to start producing errors. In the ST, there is the age old problem of chip sockets and poor contact, and early versions of the ST had some component reliability problems which could contribute to disk errors. Another source becoming more frequent is the use of extended capacity disk formats, some of which are not entirely reliable. There is also the potential of a real hardware failure in the ST, or the drive. Finally there is the potential of a virus attack. How do you tell? It's very difficult. Actually, the virus is the easiest to detect. Use your favorite virus detect program, and start searching. If you can't locate one, then you problem could be any from the list above. If you find one, you must be certain you have taken every step available to you to insure it has been eradicated before accessing your backups. When the virus does not destroy files, what does it do? It's rather like the age old "Where does a 600 pound gorilla sit?". Most anyhere he wants, obviously. A virus can do most anything that any other piece of software can do. The bigger the code segment of the virus, the more capable it can become. There are some rather surprising things accomplished by the viruses already found in boot sectors, when you consider that it has to accomplish its own loading, spreading, and eventual attack in about 120 instructions. Some of the viruses currently spreading do nothing more than mess up the screen display. When such an event occurs, it is not obvious that it is a virus attack. It could be a momentary power fluctuation, a software bug of some kind in the executing application, an intermittent hardware error, or any of several other causes. The only hope of identifying the source as a virus is, again, a methodic check of your disk library. Familiarity with the appearance of the attacks of known viruses would be helpful in recognizing when one is present. For that purpose, I have provided the program "FLU". It is a demonstration program. It does not contain any of the code present in any virus for the installation of the virus, or the spreading of the virus. What it does contain is the non-destructive attack code of several viruses. These attacks are either audio or visual, so that there is evidence of the attack occurring. There is no simulation of any of the virus attacks which cause damage to disk data, since there is no way to recognize when such an attack is occurring (and, of course, the purpose of the program is to aid in recognizing the symptoms, not to destroy disks!). "FLU" is absolutely safe. The program can be viewed as a simple novelty, which does some strange display alterations. But by running it, and becoming familiar with the symptoms it displays, you will be capable of recognizing the characteristics of the attack of several current ST viruses. Two of the simulations, the "BLOT" virus and the "SCREEN" virus, attack in a nearly identical manner. They step on a small portion of the screen. When speeded up to display the symptoms, they have the appearance of drawing lines from the top and bottom of the screen. However, when the attack occurs at the speed at which the virus really operates, the attack would appear more like a small blot appearing on the screen, since the screen would have most likely been altered or redrawn by the application program between virus attacks. The "FREEZE" virus is probably the most difficult of the non-destructive viruses to recognize, since it is the most subtle. It takes over the ST for an ever increasing period of time, causing a gradual slowing the machine. Again, the demonstration runs at a significantly higher speed than the real virus. This concludes the virus discussions. It has been the goal of these postings to inform the general public of the way viruses spread, attack, and can be dealt with. It is clear to me that, as a defense, ignorance has been unsuccessful. --