💾 Archived View for gemini.bortzmeyer.org › rfc-mirror › rfc5079.txt captured on 2023-05-24 at 20:12:35.
⬅️ Previous capture (2021-11-30)
-=-=-=-=-=-=-
Network Working Group J. Rosenberg
Request for Comments: 5079 Cisco
Category: Standards Track December 2007
Rejecting Anonymous Requests in the Session Initiation Protocol (SIP)
Status of This Memo
This document specifies an Internet standards track protocol for the
Internet community, and requests discussion and suggestions for
improvements. Please refer to the current edition of the "Internet
Official Protocol Standards" (STD 1) for the standardization state
and status of this protocol. Distribution of this memo is unlimited.
Abstract
The Session Initiation Protocol (SIP) allows for users to make
anonymous calls. However, users receiving such calls have the right
to reject them because they are anonymous. SIP has no way to
indicate to the caller that the reason for call rejection was that
the call was anonymous. Such an indication is useful to allow the
call to be retried without anonymity. This specification defines a
new SIP response code for this purpose.
Table of Contents
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . 2
2. Terminology . . . . . . . . . . . . . . . . . . . . . . . . . . 2
3. Server Behavior . . . . . . . . . . . . . . . . . . . . . . . . 3
4. UAC Behavior . . . . . . . . . . . . . . . . . . . . . . . . . 4
5. 433 (Anonymity Disallowed) Definition . . . . . . . . . . . . . 4
6. IANA Considerations . . . . . . . . . . . . . . . . . . . . . . 4
7. Security Considerations . . . . . . . . . . . . . . . . . . . . 5
8. Acknowledgements . . . . . . . . . . . . . . . . . . . . . . . 5
9. References . . . . . . . . . . . . . . . . . . . . . . . . . . 6
9.1. Normative References . . . . . . . . . . . . . . . . . . . 6
9.2. Informative References . . . . . . . . . . . . . . . . . . 6
Rosenberg Standards Track [Page 1]
RFC 5079 ACR Response Code December 2007
1. Introduction
The Session Initiation Protocol (SIP) [RFC3261] allows for users to
make anonymous calls. In RFC 3261, this is done by including a From
header field whose display name has the value of "Anonymous".
Greater levels of anonymity were subsequently defined in [RFC3323],
which introduces the Privacy header field. The Privacy header field
allows a requesting User Agent (UA) to ask for various levels of
anonymity, including user level anonymity, header level anonymity,
and session level anonymity. [RFC3325] additionally defined the
P-Asserted-Identity header field, used to contain an asserted
identity. RFC 3325 also defined the 'id' value for the Privacy
header field, which is used to request the network to remove the
P-Asserted-Identity header field.
Though users need to be able to make anonymous calls, users that
receive such calls retain the right to reject the call because it is
anonymous. SIP does not provide a response code that allows the User
Agent Server (UAS), or a proxy acting on its behalf, to explicitly
indicate that the request was rejected because it was anonymous. The
closest response code is 403 (Forbidden), which doesn't convey a
specific reason. While it is possible to include a reason phrase in
a 403 response that indicates to the human user that the call was
rejected because it was anonymous, that reason phrase is not useful
for automata and cannot be interpreted by callers that speak a
different language. An indication that can be understood by an
automaton would allow for programmatic handling, including user
interface prompts, or conversion to equivalent error codes in the
Public Switched Telephone Network (PSTN) when the client is a
gateway.
To remedy this, this specification defines the 433 (Anonymity
Disallowed) response code.
2. Terminology
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in [RFC2119].
Rosenberg Standards Track [Page 2]
RFC 5079 ACR Response Code December 2007
3. Server Behavior
A server (generally acting on behalf of the called party, though this
need not be the case) MAY generate a 433 (Anonymity Disallowed)
response when it receives an anonymous request, and the server
refuses to fulfill the request because the requestor is anonymous. A
request SHOULD be considered anonymous when the identity of the
originator of the request has been explicitly withheld by the
originator. This occurs in any one of the following cases:
o The From header field contains a URI within the anonymous.invalid
domain.
o The From header field contains a display name whose value is
either 'Anonymous' or 'anonymous'. Note that display names make a
poor choice for indicating anonymity, since they are meant to be
consumed by humans, not automata. Thus, language variations and
even misspelling can cause an automaton to miss a hint in the
display name. Despite these problems, a check on the display name
is included here because RFC 3261 explicitly calls out the usage
of the display name as a way to declare anonymity.
o The request contained a Privacy header field whose value indicates
that the user wishes its identity withheld. Values meeting this
criteria are 'id' [RFC3325] or 'user'.
o The From header field contains a URI that has an explicit
indication that it is anonymous. One such example of a mechanism
that would meet this criteria is [coexistence]. This criteria is
true even if the request has a validated Identity header field
[RFC4474], which can be used in concert with anonymized From
header fields.
Lack of a network-asserted identity (such as the P-Asserted-Identity
header field), in and of itself, SHOULD NOT be considered an
indication of anonymity. Even though a Privacy header field value of
'id' will cause the removal of a network-asserted identity, there is
no way to differentiate this case from one in which a network-
asserted identity was not supported by the originating domain. As a
consequence, a request without a network-asserted identity is
considered anonymous only when there is some other indication of
this, such as a From header field with a display name of 'Anonymous'.
In addition, requests where the identity of the requestor cannot be
determined or validated, but it is not a consequence of an explicit
action on the part of the requestor, are not considered anonymous.
For example, if a request contains a non-anonymous From header field,
along with the Identity and Identity-Info header fields [RFC4474],
Rosenberg Standards Track [Page 3]
RFC 5079 ACR Response Code December 2007
but the certificate could not be obtained from the reference in the
Identity-Info header field, it is not considered an anonymous
request, and the 433 response code SHOULD NOT be used.
4. UAC Behavior
A User Agent Client (UAC) receiving a 433 (Anonymity Disallowed) MUST
NOT retry the request without anonymity unless it obtains
confirmation from the user that this is desirable. Such confirmation
could be obtained through the user interface, or by accessing user-
defined policy. If the user has indicated that this is desirable,
the UAC MAY retry the request without requesting anonymity. Note
that if the UAC were to automatically retry the request without
anonymity in the absence of an indication from the user that this
treatment is desirable, then the user's expectations would not be
met. Consequently, a user might think it had completed a call
anonymously when it is not actually anonymous.
Receipt of a 433 response to a mid-dialog request SHOULD NOT cause
the dialog to terminate, and SHOULD NOT cause the specific usage of
that dialog to terminate [RFC5057].
A UAC that does not understand or care about the specific semantics
of the 433 response will treat it as a 400 response.
5. 433 (Anonymity Disallowed) Definition
This response indicates that the server refused to fulfill the
request because the requestor was anonymous. Its default reason
phrase is "Anonymity Disallowed".
6. IANA Considerations
This section registers a new SIP response code according to the
procedures of RFC 3261.
RFC Number: RFC 5079
Response Code Number: 433
Default Reason Phrase: Anonymity Disallowed
Rosenberg Standards Track [Page 4]
RFC 5079 ACR Response Code December 2007
7. Security Considerations
The fact that a request was rejected because it was anonymous does
reveal information about the called party -- that the called party
does not accept anonymous calls. This information may or may not be
sensitive. If it is, a UAS SHOULD reject the request with a 403
instead.
In the Public Switched Telephone Network (PSTN), the Anonymous Call
Rejection (ACR) feature is commonly used to prevent unwanted calls
from telemarketers (also known as spammers). Since telemarketers
frequently withhold their identity, anonymous call rejection has the
desired effect in many (but not all) cases. It is important to note
that the response code described here is likely to be ineffective in
blocking SIP-based spam. The reason is that a malicious caller can
include a From header field and display name that is not anonymous,
but is meaningless and invalid. Without a Privacy header field, such
a request will not appear anonymous and thus not be blocked by an
anonymity screening service. Dealing with SIP-based spam is not a
simple problem. The reader is referred to [sipping-spam] for a
discussion of the problem.
When anonymity services are being provided as a consequence of an
anonymizer function acting as a back-to-back user agent (B2BUA)
[RFC3323], and the anonymizer receives a 433 response, the anonymizer
MUST NOT retry the request without anonymization unless it has been
explicitly configured by the user to do so. In essence, the same
rules that apply to a UA in processing of a 433 response apply to a
network-based anonymization function, and for the same reasons.
8. Acknowledgements
This document was motivated based on the requirements in
[tispan-req], and has benefited from the concepts in [hautakorpi].
Thanks to Keith Drage, Paul Kyzivat, and John Elwell for their
reviews of this document.
Rosenberg Standards Track [Page 5]
RFC 5079 ACR Response Code December 2007
9. References
9.1. Normative References
[RFC3261] Rosenberg, J., Schulzrinne, H., Camarillo, G.,
Johnston, A., Peterson, J., Sparks, R., Handley, M.,
and E. Schooler, "SIP: Session Initiation Protocol",
RFC 3261, June 2002.
[RFC3323] Peterson, J., "A Privacy Mechanism for the Session
Initiation Protocol (SIP)", RFC 3323, November 2002.
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119, March 1997.
[RFC4474] Peterson, J. and C. Jennings, "Enhancements for
Authenticated Identity Management in the Session
Initiation Protocol (SIP)", RFC 4474, August 2006.
9.2. Informative References
[RFC3325] Jennings, C., Peterson, J., and M. Watson, "Private
Extensions to the Session Initiation Protocol (SIP)
for Asserted Identity within Trusted Networks",
RFC 3325, November 2002.
[coexistence] Rosenberg, J., "Coexistence of P-Asserted-ID and SIP
Identity", Work in Progress, June 2006.
[tispan-req] Jesske, R., "Input Requirements for the Session
Initiation Protocol (SIP) in support for the
European Telecommunications Standards Institute",
Work in Progress, July 2007.
[hautakorpi] Hautakorpi, J. and G. Camarillo, "Extending the
Session Initiation Protocol Reason Header with
Warning Codes", Work in Progress, October 2005.
[RFC5057] Sparks, R., "Multiple Dialog Usages in the Session
Initiation Protocol", RFC in 5057, November 2007.
[sipping-spam] Jennings, C. and J. Rosenberg, "The Session
Initiation Protocol (SIP) and Spam", Work
in Progress, August 2007.
Rosenberg Standards Track [Page 6]
RFC 5079 ACR Response Code December 2007
Author's Address
Jonathan Rosenberg
Cisco
Edison, NJ
US
EMail: jdrosen@cisco.com
URI: http://www.jdrosen.net
Rosenberg Standards Track [Page 7]
RFC 5079 ACR Response Code December 2007
Full Copyright Statement
Copyright (C) The IETF Trust (2007).
This document is subject to the rights, licenses and restrictions
contained in BCP 78, and except as set forth therein, the authors
retain all their rights.
This document and the information contained herein are provided on an
"AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY, THE IETF TRUST AND
THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF
THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Intellectual Property
The IETF takes no position regarding the validity or scope of any
Intellectual Property Rights or other rights that might be claimed to
pertain to the implementation or use of the technology described in
this document or the extent to which any license under such rights
might or might not be available; nor does it represent that it has
made any independent effort to identify any such rights. Information
on the procedures with respect to rights in RFC documents can be
found in BCP 78 and BCP 79.
Copies of IPR disclosures made to the IETF Secretariat and any
assurances of licenses to be made available, or the result of an
attempt made to obtain a general license or permission for the use of
such proprietary rights by implementers or users of this
specification can be obtained from the IETF on-line IPR repository at
http://www.ietf.org/ipr.
The IETF invites any interested party to bring to its attention any
copyrights, patents or patent applications, or other proprietary
rights that may cover technology that may be required to implement
this standard. Please address the information to the IETF at
ietf-ipr@ietf.org.
Rosenberg Standards Track [Page 8]