💾 Archived View for gemini.spam.works › mirrors › textfiles › uploads › bong.txt captured on 2023-01-29 at 12:48:08.
⬅️ Previous capture (2020-10-31)
-=-=-=-=-=-=-
Making Your Very Own Bong That You Can ReUse
By PHiSH
Making a Bong is really easy... :)
Materials Needed:
1: 1/4" aluminum tubing (that's 1/4" on the outside... not the inside)
(Make sure this is ALUMINUM tubing an NOT COPPER, Heating copper tubing
and inhaling the fumes can kill you!!)
2: Glass Bottle with fitting lid or double holed stopper (holes must be 1/4")
3: Drill + 1/4" Drill Bit OR 1/4" punch
4: 1/4" Socket for a Socket Wrench, best to use the biggest size you can
find that still fit's the 1/4" wrench
5: Fine screen, like the one you'd use in a pipe, available at most
bong/pipe selling stores
Procedure:
1: Drill two 1/4" holes in the lid
2: Cut about 4" (depending on the size of your bong) of Al. tubing
3: Curve the 4"'s os tubing to 90 degrees
4: Put the lid with the holes onto the glass bottle
5: Put the 4" Curved piece of tubing into one of the holes
6: Straighten the rest of the tubing and put it into the other hole
7: Slide the big piece of tubing all the way down so it touches the bottom
8: Curve the bottom of the Big piece just a tad
9: Cut the top of the big peice of tubing about 1" or 2" above the cap
10: Put the screen in the big side socket
11: Put the socket on the end of the big tube
12: Pull the tube assembly out of the bottle and fill the bottle about
half full with water
13: Obtain some Marijuana and smoke it
Picture (As best I can draw it)
__
\ |_|
_|_|_
| | | |
| | | |
/ | \
| | | <----Water Fill Level
| | |
| \ |
^^^^^^^^^