💾 Archived View for gemini.spam.works › mirrors › textfiles › phreak › u16.phk captured on 2023-01-29 at 10:50:42.
⬅️ Previous capture (2020-10-31)
-=-=-=-=-=-=-
Icom U16 Programming
---------------------------------------------------------------------------
The U16 is made programmable by moving a jumper inside the unit, then try
holding [FUNC] down and entering 159357. You're now in programming mode.
Exit program mode with [FUNC] + [CLR].
Function + 159357 Enter programming mode (Function = [FUNC] key)
Function + [1] PL (CTCSS) Encoder tones (1-37)
+ [2] PL (CTCSS) Decoder tones (1-37)
1= 67.0 2= 71.9 3= 74.4 4= 77.0 5= 79.7
6= 82.5 7= 85.4 8= 88.5 9= 91.5 10= 94.8
11=100.0 12=103.5 13=107.2 14=110.9 15=114.8
16=118.8 17=123.0 18=127.3 19=131.8 20=136.5
21=141.3 22=146.2 23=151.4 24=156.7 25=162.2
26=167.9 27=173.8 28=179.9 29=186.2 30=192.8
31=203.5 32=210.7 33=218.1 34=225.7 35=233.6
36=241.8 37=250.3 (Tone 97.4 Not Available)
+ [3] ?
+ [4] Delta + / Delta - offset, 5 digits
+ [5] Frequency, 5 digits (400MHz +)
+ [6] ?
+ [7] Special Channel Number (allows alias ch.17-99 number)
+ [8] Transmit timeout enable.
+ [9] TI - Transmit Inhibit
+ [SCAN] Priority Scan/Ch Scan
+ [S.CH] Channel Masking
+ [CLEAR] End progamming mode
---------------------------------------------------------------------------
Channel select: Standard method (up/down arrows or CH# + [ENTER])
Frequency: Hold [FUNC], Press [5], enter 6 dig freq, [ENTER], Release
[FUNC]
Rx CTCSS: Hold [FUNC], Press [2], enter 2 dig code, [ENTER], Release
[FUNC]
Tx CTCSS: Hold [FUNC], Press [1], enter 2 dig code, [ENTER], Release
[FUNC]
Offset Freq: Hold [FUNC], Press [4], use [#] for up offset, [*] for
down offset, then enter freq to offset by (ie: [#] [0] [0]
[0] [0] [0] for no offset, [#] [0] [5] [0] [0] [0] for the
standard +5MHz UHF offset), [ENTER], Release [FUNC]
Timeout Timer: Hold [FUNC], [8], Release [FUNC]
Tx Inhibit: Hold [FUNC], [9], Release [FUNC]
Special Ch. #: Hold [FUNC], Press [7], enter the special
channel number (17-99), [ENTER], Release [FUNC]
Data Transfer
MASTER: Hold [FUNC], [BEEP], Release [FUNC]
SLAVE: Hold [FUNC] with power off, turn on, Release [FUNC]
---------------------------------------------------------------------------
-/Vuarnet International/-
617/527.oo91
24oo-16.8k HST/V32bis