💾 Archived View for gemini.spam.works › mirrors › textfiles › hamradio › micro2.ham captured on 2023-01-29 at 08:07:03.
⬅️ Previous capture (2020-10-31)
-=-=-=-=-=-=-
===== BAND EXPANSION MODIFICATION FOR ICOM MICRO2 =====
1. Remove battery.
2. Remove 4 screws securing batter. Slide from fron panel.
3. Remove small black screw below PTT switch.
4. Carefully separate the fron speaker from the body by pulling front
and rear down toward battery. Flip it over.
5. Next remove steel chassis assembly by gently prying up the sides,
lift up, fold it down.
6. Solder in new diode next to Q131 and Diode D113. Looking at Diode
Matrix with top of radio to the top, add diode to the empty pad to
the left of diode D119. There are 3 points of connection on the
diode pad. Two on the left and on centered vertically on the right.
The diode should be installed between the lower left and the right
centered connection. (Arrow on diode points to right centered connection.)
7. Reset CPU by following instruction manual page 23.
----------------------------------
***->Be careful not to transmit out-of-band, or accidentally operate on
any non-amateur, unless you are authorized to do so.
DO NOT JEOPARDIZE YOUR LICENSE!
RELAYED BY...N0KGX...GENE