💾 Archived View for gemini.spam.works › mirrors › textfiles › phreak › BOXES › silverp.box captured on 2022-07-17 at 10:43:42.

View Raw

More Information

⬅️ Previous capture (2022-06-12)

-=-=-=-=-=-=-



                                                          *
    MEMBER NAME: PORTSILB                                 *
                                                          *


  ***************************************
  *            How to make a            *
  *         Portable Silver Box         *
  *                                     *
  *          By:                        *
  *              The                    *
  *                Phone                *
  *                    Phantom          *
  *                                     *
  ***************************************


    This will tell you how to make a
  portable silver box out of:

         A Radio Shack touch tone pad
         Some wire
         A Soldering iron
         And a SPDT switch

  NOTE: You should have an I.Q. above room tempature before
  attempting this.  Also, read all of this article before
  starting.

  WARNING: This may be hazardous to your freedom.

  1} Take off the plastic cover that stores the batteries and
  remove the screw that is in the center of the batteries. Now use
  a screw driver to pry open the box.
  2} Now you should have the two halves in your hands. On the side
  that has the circuit board, it should be held by two clips.
  Remove the circuit board now.

  3} You should now be able to see the back side of the keypad.
  Connecting the the key pad and the circuit board is a ribben
  cable. With the ribben ends connected to the keypad away from
  you, count from the left over four wires.  On the fourth wire,
  take and cut the plastic on either side on the wire.  Then
  desolder it.

  4} Now stare at the circuit board. Look at the connections of
  the chip.  (SEE FIG.) There should be four pins not connected to
  anything. On the ninth pin (first row, first pin) solder a 3
  inch wire to it. The other end goes to the left side of the spdt
  switch.

  5} Go back to the cable. Solder a 2 inch to the ribben cable you
  just took out. This is because it won't reach the switch. The
  other end goes to right side of the switch.

  6} Now take a two inch wire and solder it to the hole that the
  cable came out of. Becareful not to get solder on the other
  wires. Now take the other end and solder it to the middle of the
  switch.

  7} Make a hole in the top of the case to put the switch through.
  And put it back together.

  THE FIGURE OF THE CHIP.

  THE PIN >9< 10 11 12 13 14 15 16

           1  2  3  4  5  6  7  8

  (Pretty cool eh?)

  _______________________________________

  Switch the switch left according to the way you soldered it to
  make silver box tones on the 3,6,9, and # keys.  Switch it to
  the right for a normal key pad.  Switching it to the middle does
  NOTHING!!!!

  This silver is small enough to fit in your pocket for phreaking
  at your nearest pay phone or where ever.

  This file is for information only (RIGHT!) ha ha ha!

  Written by:

              The
                Phone
                    Phantom

N