💾 Archived View for gemini.spam.works › mirrors › textfiles › phreak › BOXES › silver captured on 2022-07-17 at 10:43:16.
⬅️ Previous capture (2022-06-12)
-=-=-=-=-=-=-
HOW TO BUILD A SILVER BOX
MATERIALS : Soldering iron and solder
22 ga. wire
SPDT switch
screwdriver
PROCEDURE
1) Unscrew your phone (must be a touch tone, desk type)
2) Remove the mounted pad and take the clear plastic cover from the bottom.
3) Hold the pad with the numbers 0, *, # facing you, and turn it upside down,
so you can see the yellow pc board.
4) You should see 2 black round doughnuts.
5) Position the board so the solder points for the left doughnut face you.
6) Count over four points from the left, and attach a (green) wire to that
point.
7) Between you and the doughnuts, there should be 2 long yellow capacitors.
To the right of these, and on the edge of the board there should be 3 gold
contacts. We will use the one on the left.
8) The contact originally is spot welded, so snip it open.
9) To the one nearest you, attach a (red) wire; to the other one, a (yellow)
wire.
10) Run the wires out of the phone, and solder the switch.
11) The orientation should be (red) to center. The switch will now alternate
between normal and 1633hz fourth column tones.