💾 Archived View for gemini.spam.works › mirrors › textfiles › phreak › BOXES › mauve.box captured on 2022-06-12 at 17:19:13.
View Raw
More Information
-=-=-=-=-=-=-
- **********************************************************
*
MEMBER NAME: MAUVE *
*
- **********************************************************
_________________________
/~~~~~~~~~~~~~~~~~~~~~~~~~\
| How to Build Your Own |
| |
| |\ /| _ __ |
| | \/ | |_| | | | | |__ |
| | | | | |_| \/ |__ |
| __ |
| | \ _ |
| |__/ / \ \_/ |
| | \ \_/ / \ |
| |__/ / |
| _________/ |
| |
\_________________________/
~~~~~~~~~~~~~~~~~~~~~~~~~
____________________________
| Created by Captian Generic |
| With Help from The Genetic |
| Mishap. This File Created |
| November 24th, 1986, 19:08 |
~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Please bear with me, as the construction of this box will seem rather
silly. This box was found in a construction site. Or rather, it found
us at a construction site. We were using a $5 Radio Shack phone out of
a semi-completed office building. One afternoon during a holiday, and
immediately following a storm, we found our bus in shambles. To our
suprise, we also found that one of the phone connections we were tapping
had been draped through a murky puddle. The fact that suprised us even
more was that this line still worked and now posessed some great
capibilities.
Materials:
2 tupperware or similar 8oz contianers
1 small bag earth (dirt) (12oz)
1 pint water
2 lantern batteries
1 nine volt battery
1 battery clip
2 SPST switches
4 ounces of iron shavings
2 polar magnets
5 feet wire
1 set soldering equipment
This is the part you won't believe. Take the tupperware containers, and
fill them with a mixture of the earth and the iron shavings. Make sure
that the mixture is well done. (*NOTE* for best results, use the sand in
fine ash trays.) Cut the cut the red and green wires and splice the
switches into them. From the switches, solder wire to the magnets.
Connect the red to the + (positive) side of one magnet, and the green to
the - (negative) side of the second magnet. From the other poles of the
magnet, solder wires the battery & clip. Make sure the + (positive) and
- (negative) are correct. Set the nine-volt battery between the two
tupperware containers and place the battery end of the two magnets into
the tupperware. Now connect wire to the two poles of the lantern
battery, and place them in the same containers as the poles of the
magnets/9-volt battery. You are almost done. Finally, add just enough
water to the two pots, and let them sit in the sun and bake like bricks.
at this point, you have a MAUVE BOX.
Explaning and Using What You Have:
The red and green wires have been places into a magnetic field which is
being charged continually be a lantern battery. (It is necessary to
change this battery every one to one and a half months.) This will
literaly pull in the nearest phone conversatiion. (Don't try this in a
big apartment or dorm.) When the 9-volt battery is connected, this will
now create enough current for the poles of the magnets to reverse
themselves (perhaps you're seen Mr. Wizard do this. It's just like with
the soap). At this point, you have a phone transmitting to one (if not
more) of the nearest phones. (Again, if you're in a dorm, don't try
this.) I suppose this just accomplishes what a tap would do, but with a
MAUVE BOX, your fingerprints never will show on a terminal or on
someones telephone lines.
Notes and Addendum:
This will only work with a touch-tone phone connected to a phone line.
When the switches are pulled, it's off your line and into the air. This
is named a MAUVE BOX, becuase this is the most disgusting box, and I find
mauve to be the single most disgusting colour I know of. Also, this file
is for information purposes only. This is not to be used in an illegal
manner. Perhaps one of these by the pool, sending to your seth co-author,
accept no responsibility for your actions with the MAUVE BOX. Thank you..
.