💾 Archived View for gemini.spam.works › mirrors › textfiles › phreak › CELLULAR › p3.txt captured on 2022-06-12 at 17:29:51.
-=-=-=-=-=-=-
-//-> The Citronic Cellular Suite :: NEC P3 Reprogramming <-\\-
In this package you will find the reprogramming software imaginatively
titled 'P3.EXE'. This text file shows a diagram of the programming cable.
.+[You will need]+.
2 x 1N4148 Diodes
25-pin D-Plug
Plug for P3's socket
To get the plug for the phones 'up-the-bum' socket you will need to buy
the car saver. Simply cut the cigaretter lighter end off the cable and
keep the rest.
From the cigarette lighter end find the wires that correspond to the
correct pins on the P3 plug as per the diagram below and solder on to
the relevant pins of the D-plug. Don't forget to solder the diodes on
the right way round. I would recommend putting a decent case around the
D-25 plug as they can undergo a good deal of stress with continuous use.
25 Pin D-plug LPT1 Plug on end of curly cord
__________________ _________________________
Pin 25.--------------------black--------------------------------------|
Pin 15.--------------------red-------------------------------------| |
Pin 6.---|<In4148--| | |
Pin 13.-------------|------white--------------------------------| | |
|| [] [] [] [] [] []
view into plug: Aerial---><>
Pin 3.---|<1N4148---| || [] [] [] [] [] []
Pin 12.--------------|-----brown--------------------------------|
NOTE Diode protocol: Kathode---|<diode---Anode
Once that is done, simply connect up the cable and fire up the software!
Enter the ESN you wish to program the phone with. Next you must enter the
phone number. (Note: You need to use the normal 0850 etc. prefixes not in
2342 format). The software currently does not accept the new 0585 Cellnet
prefixed numbers. However it will accept 0374 numbers. If you do need to
program one with an 0585 number, just enter a valid number, and change it
with the handset by entering test mode. Lastly you can choose a 4-digit
unlock code and then you are ready to program. Enter 'Y' at the "Reset and
Initialise" prompt and your phone will be programmed up for you ready to go.
::Pulse/Citronic::