💾 Archived View for gemini.bortzmeyer.org › rfc-mirror › rfc7886.txt captured on 2022-06-04 at 00:24:00.
⬅️ Previous capture (2021-11-30)
-=-=-=-=-=-=-
Internet Engineering Task Force (IETF) V. Govindan Request for Comments: 7886 C. Pignataro Category: Standards Track Cisco ISSN: 2070-1721 July 2016 Advertising Seamless Bidirectional Forwarding Detection (S-BFD) Discriminators in the Layer Two Tunneling Protocol Version 3 (L2TPv3) Abstract This document defines a new Attribute-Value Pair (AVP) that allows L2TP Control Connection Endpoints (LCCEs) to advertise one or more Seamless Bidirectional Forwarding Detection (S-BFD) Discriminator values using the Layer Two Tunneling Protocol version 3 (L2TPv3). Status of This Memo This is an Internet Standards Track document. This document is a product of the Internet Engineering Task Force (IETF). It represents the consensus of the IETF community. It has received public review and has been approved for publication by the Internet Engineering Steering Group (IESG). Further information on Internet Standards is available in Section 2 of RFC 7841. Information about the current status of this document, any errata, and how to provide feedback on it may be obtained at http://www.rfc-editor.org/info/rfc7886. Copyright Notice Copyright (c) 2016 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Govindan & Pignataro Standards Track [Page 1] RFC 7886 S-BFD Discriminators in L2TPv3 July 2016 Table of Contents 1. Introduction ....................................................2 1.1. Terminology ................................................2 2. S-BFD Target Discriminator ID AVP ...............................2 2.1. Encoding Format ............................................3 3. IANA Considerations .............................................4 4. Security Considerations .........................................4 5. References ......................................................5 5.1. Normative References .......................................5 5.2. Informative References .....................................5 Acknowledgements ...................................................6 Contributors .......................................................6 Authors' Addresses .................................................6 1. Introduction [RFC7880] defines a simplified mechanism to use Bidirectional Forwarding Detection (BFD) [RFC5880], referred to as Seamless Bidirectional Forwarding Detection (S-BFD). The S-BFD mechanism depends on network nodes knowing the BFD Discriminators that each node in the network has reserved for this purpose. S-BFD requires the usage of unique discriminators within an administrative domain. The use of the Layer Two Tunneling Protocol version 3 (L2TPv3) [RFC3931] is one possible means of advertising these discriminators. This document specifies the encoding to be used when S-BFD Discriminators are advertised using L2TPv3. 1.1. Terminology The reader is expected to be very familiar with the terminology and protocol constructs defined in S-BFD (see Section 2 of [RFC7880]) and L2TPv3 (see Section 1.3 of [RFC3931]). The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119 [RFC2119]. 2. S-BFD Target Discriminator ID AVP The S-BFD Target Discriminator Identifier (ID) Attribute Value Pair (AVP) is exchanged using the ICRQ (Incoming-Call-Request), ICRP (Incoming-Call-Reply), OCRQ (Outgoing-Call-Request), and OCRP (Outgoing-Call-Reply) control messages during session negotiation. Govindan & Pignataro Standards Track [Page 2] RFC 7886 S-BFD Discriminators in L2TPv3 July 2016 2.1. Encoding Format The S-BFD Target Discriminator ID AVP, Attribute Type 102, is an identifier used to advertise the S-BFD target discriminator(s) supported by an L2TP Control Connection Endpoint (LCCE) for the S-BFD reflector operation. This AVP indicates that the advertiser implements an S-BFD reflector supporting the specified target discriminator(s) and is ready for S-BFD reflector operation. The receiving LCCE MAY use this AVP if it wants to monitor connectivity to the advertising LCCE using S-BFD. The Attribute Value field for this AVP has the following format: S-BFD Target Discriminator ID (ICRQ, ICRP, OCRQ, OCRP): No. of octets +-----------------------------+ | Discriminator Value(s) | 4/Discriminator : : +-----------------------------+ An LCCE MAY include the S-BFD Target Discriminator ID AVP advertisement in an L2TP control message (ICRQ, ICRP, OCRQ, OCRP) [RFC3931]. If the other LCCE does not wish to monitor connectivity using S-BFD, it MAY safely discard this AVP without affecting the rest of session negotiation. While [RFC7880] concerns itself with the advertisement of only one discriminator unless the mapping of discriminators to entities is specified, the AVP encoding allows the specification of an arbitrary number of S-BFD Discriminators (at least one) for extensibility. When an LCCE uses the S-BFD Target Discriminator ID AVP advertisement, multiple S-BFD Discriminators MAY be included, and at least one S-BFD Discriminator MUST be included. When one S-BFD Discriminator is advertised, such an S-BFD Discriminator is associated with the L2TPv3 session. When multiple S-BFD Discriminators are advertised, how a given discriminator is mapped to a specific use case is out of scope for this document. Govindan & Pignataro Standards Track [Page 3] RFC 7886 S-BFD Discriminators in L2TPv3 July 2016 The S-BFD Target Discriminator ID AVP allows for advertising at least one S-BFD Discriminator value: 0 1 2 3 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Discriminator 1 | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Discriminator 2 (Optional) | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | ... | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Discriminator n (Optional) | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ The M bit of the L2TP control message (ICRQ, ICRP, OCRQ, OCRP) [RFC3931] MUST NOT be set inside the S-BFD Target Discriminator ID AVP. 3. IANA Considerations IANA maintains the "Control Message Attribute Value Pairs" sub-registry as per [RFC3438]. IANA has assigned the following value to the S-BFD Target Discriminator ID: Control Message Attribute Value Pairs Attribute Type Description ----------- ------------------ 102 S-BFD Target Discriminator ID 4. Security Considerations Security concerns for L2TP are addressed in [RFC3931]. The introduction of the S-BFD Target Discriminator ID AVP advertisement introduces no new security risks for L2TP. Advertising the S-BFD Discriminators makes it possible for attackers to initiate S-BFD sessions using the advertised information. The vulnerabilities this poses and how to mitigate them are discussed in the Security Considerations section of [RFC7880]. Govindan & Pignataro Standards Track [Page 4] RFC 7886 S-BFD Discriminators in L2TPv3 July 2016 5. References 5.1. Normative References [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, March 1997, <http://www.rfc-editor.org/info/rfc2119>. [RFC3438] Townsley, W., "Layer Two Tunneling Protocol (L2TP) Internet Assigned Numbers Authority (IANA) Considerations Update", BCP 68, RFC 3438, DOI 10.17487/RFC3438, December 2002, <http://www.rfc-editor.org/info/rfc3438>. [RFC3931] Lau, J., Ed., Townsley, M., Ed., and I. Goyret, Ed., "Layer Two Tunneling Protocol - Version 3 (L2TPv3)", RFC 3931, DOI 10.17487/RFC3931, March 2005, <http://www.rfc-editor.org/info/rfc3931>. [RFC7880] Pignataro, C., Ward, D., Akiya, N., Bhatia, M., and S. Pallagatti, "Seamless Bidirectional Forwarding Detection (S-BFD)", RFC 7880, DOI 10.17487/RFC7880, July 2016, <http://www.rfc-editor.org/info/rfc7880>. 5.2. Informative References [RFC5880] Katz, D. and D. Ward, "Bidirectional Forwarding Detection (BFD)", RFC 5880, DOI 10.17487/RFC5880, June 2010, <http://www.rfc-editor.org/info/rfc5880>. Govindan & Pignataro Standards Track [Page 5] RFC 7886 S-BFD Discriminators in L2TPv3 July 2016 Acknowledgements The authors would like to thank Nobo Akiya, Stewart Bryant, and Pawel Sowinski for providing core inputs for the document, performing thorough reviews, and providing a number of comments. The authors would also like to thank Nagendra Kumar for his reviews. Contributors Mallik Mudigonda Cisco Systems, Inc. Email: mmudigon@cisco.com Authors' Addresses Vengada Prasad Govindan Cisco Systems, Inc. Email: venggovi@cisco.com Carlos Pignataro Cisco Systems, Inc. Email: cpignata@cisco.com Govindan & Pignataro Standards Track [Page 6]