💾 Archived View for gemini.bortzmeyer.org › rfc-mirror › rfc2013.txt captured on 2022-06-04 at 03:41:29.
⬅️ Previous capture (2021-11-30)
-=-=-=-=-=-=-
Network Working Group K. McCloghrie, Editor Request for Comments: 2013 Cisco Systems Updates: 1213 November 1996 Category: Standards Track SNMPv2 Management Information Base for the User Datagram Protocol using SMIv2 Status of this Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. IESG Note: The IP, UDP, and TCP MIB modules currently support only IPv4. These three modules use the IpAddress type defined as an OCTET STRING of length 4 to represent the IPv4 32-bit internet addresses. (See RFC 1902, SMI for SNMPv2.) They do not support the new 128-bit IPv6 internet addresses. Table of Contents 1. Introduction ................................................. 1 2. Definitions .................................................. 2 2.1 The UDP Group ............................................... 3 2.2 Conformance Information ..................................... 5 2.2.1 Compliance Statements ..................................... 5 2.2.2 Units of Conformance ...................................... 5 3. Acknowledgements ............................................. 6 4. References ................................................... 6 5. Security Considerations ...................................... 6 6. Editor's Address ............................................. 6 1. Introduction A management system contains: several (potentially many) nodes, each with a processing entity, termed an agent, which has access to management instrumentation; at least one management station; and, a management protocol, used to convey management information between the agents and management stations. Operations of the protocol are carried out under an administrative framework which defines authentication, authorization, access control, and privacy policies. McCloghrie Standards Track [Page 1] RFC 2013 SNMPv2 MIB for UDP November 1996 Management stations execute management applications which monitor and control managed elements. Managed elements are devices such as hosts, routers, terminal servers, etc., which are monitored and controlled via access to their management information. Management information is viewed as a collection of managed objects, residing in a virtual information store, termed the Management Information Base (MIB). Collections of related objects are defined in MIB modules. These modules are written using a subset of OSI's Abstract Syntax Notation One (ASN.1) [1], termed the Structure of Management Information (SMI) [2]. This document is the MIB module which defines managed objects for managing implementations of the User Datagram Protocol (UDP) [3]. The managed objects in this MIB module were originally defined using the SNMPv1 framework as a part of MIB-II [4]. This document defines the same objects for UDP using the SNMPv2 framework. 2. Definitions UDP-MIB DEFINITIONS ::= BEGIN IMPORTS MODULE-IDENTITY, OBJECT-TYPE, Counter32, IpAddress, mib-2 FROM SNMPv2-SMI MODULE-COMPLIANCE, OBJECT-GROUP FROM SNMPv2-CONF; udpMIB MODULE-IDENTITY LAST-UPDATED "9411010000Z" ORGANIZATION "IETF SNMPv2 Working Group" CONTACT-INFO " Keith McCloghrie Postal: Cisco Systems, Inc. 170 West Tasman Drive San Jose, CA 95134-1706 US Phone: +1 408 526 5260 Email: kzm@cisco.com" McCloghrie Standards Track [Page 2] RFC 2013 SNMPv2 MIB for UDP November 1996 DESCRIPTION "The MIB module for managing UDP implementations." REVISION "9103310000Z" DESCRIPTION "The initial revision of this MIB module was part of MIB- II." ::= { mib-2 50 } -- the UDP group udp OBJECT IDENTIFIER ::= { mib-2 7 } udpInDatagrams OBJECT-TYPE SYNTAX Counter32 MAX-ACCESS read-only STATUS current DESCRIPTION "The total number of UDP datagrams delivered to UDP users." ::= { udp 1 } udpNoPorts OBJECT-TYPE SYNTAX Counter32 MAX-ACCESS read-only STATUS current DESCRIPTION "The total number of received UDP datagrams for which there was no application at the destination port." ::= { udp 2 } udpInErrors OBJECT-TYPE SYNTAX Counter32 MAX-ACCESS read-only STATUS current DESCRIPTION "The number of received UDP datagrams that could not be delivered for reasons other than the lack of an application at the destination port." ::= { udp 3 } udpOutDatagrams OBJECT-TYPE SYNTAX Counter32 MAX-ACCESS read-only STATUS current DESCRIPTION "The total number of UDP datagrams sent from this entity." ::= { udp 4 } McCloghrie Standards Track [Page 3] RFC 2013 SNMPv2 MIB for UDP November 1996 -- the UDP Listener table -- The UDP listener table contains information about this -- entity's UDP end-points on which a local application is -- currently accepting datagrams. udpTable OBJECT-TYPE SYNTAX SEQUENCE OF UdpEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "A table containing UDP listener information." ::= { udp 5 } udpEntry OBJECT-TYPE SYNTAX UdpEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "Information about a particular current UDP listener." INDEX { udpLocalAddress, udpLocalPort } ::= { udpTable 1 } UdpEntry ::= SEQUENCE { udpLocalAddress IpAddress, udpLocalPort INTEGER } udpLocalAddress OBJECT-TYPE SYNTAX IpAddress MAX-ACCESS read-only STATUS current DESCRIPTION "The local IP address for this UDP listener. In the case of a UDP listener which is willing to accept datagrams for any IP interface associated with the node, the value 0.0.0.0 is used." ::= { udpEntry 1 } udpLocalPort OBJECT-TYPE SYNTAX INTEGER (0..65535) MAX-ACCESS read-only STATUS current DESCRIPTION "The local port number for this UDP listener." ::= { udpEntry 2 } McCloghrie Standards Track [Page 4] RFC 2013 SNMPv2 MIB for UDP November 1996 -- conformance information udpMIBConformance OBJECT IDENTIFIER ::= { udpMIB 2 } udpMIBCompliances OBJECT IDENTIFIER ::= { udpMIBConformance 1 } udpMIBGroups OBJECT IDENTIFIER ::= { udpMIBConformance 2 } -- compliance statements udpMIBCompliance MODULE-COMPLIANCE STATUS current DESCRIPTION "The compliance statement for SNMPv2 entities which implement UDP." MODULE -- this module MANDATORY-GROUPS { udpGroup } ::= { udpMIBCompliances 1 } -- units of conformance udpGroup OBJECT-GROUP OBJECTS { udpInDatagrams, udpNoPorts, udpInErrors, udpOutDatagrams, udpLocalAddress, udpLocalPort } STATUS current DESCRIPTION "The udp group of objects providing for management of UDP entities." ::= { udpMIBGroups 1 } END McCloghrie Standards Track [Page 5] RFC 2013 SNMPv2 MIB for UDP November 1996 3. Acknowledgements This document contains a modified subset of RFC 1213. 4. References [1] Information processing systems - Open Systems Interconnection Specification of Abstract Syntax Notation One (ASN.1), International Organization for Standardization. International Standard 8824, (December, 1987). [2] McCloghrie, K., Editor, "Structure of Management Information for version 2 of the Simple Network Management Protocol (SNMPv2)", RFC 1902, Cisco Systems, January 1996. [3] Postel, J., "User Datagram Protocol", STD 6, RFC 768, USC-ISI, August 1980. [4] McCloghrie, K., and Rose, M., "Management Information Base for Network Management of TCP/IP-based internets: MIB-II", STD 17, RFC 1213, March 1991. 5. Security Considerations Security issues are not discussed in this memo. 6. Editor's Address Keith McCloghrie Cisco Systems, Inc. 170 West Tasman Drive San Jose, CA 95134-1706 US Phone: +1 408 526 5260 EMail: kzm@cisco.com McCloghrie Standards Track [Page 6]