💾 Archived View for gemini.bortzmeyer.org › rfc-mirror › rfc2602.txt captured on 2022-04-28 at 23:16:54.
⬅️ Previous capture (2021-11-30)
-=-=-=-=-=-=-
Network Working Group M. Davison
Request for Comments: 2602 Cisco Systems
Category: Standards Track June 1999
ILMI-Based Server Discovery for MARS
Status of this Memo
This document specifies an Internet standards track protocol for the
Internet community, and requests discussion and suggestions for
improvements. Please refer to the current edition of the "Internet
Official Protocol Standards" (STD 1) for the standardization state
and status of this protocol. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (1999). All Rights Reserved.
Abstract
This memo defines how ILMI-based Server Discovery, which provides a
method for ATM-attached hosts and routers to dynamically determine
the ATM addresses of servers, shall be used to locate MARS servers.
1. Introduction
Presently, configuring a host or router to use MARS [1] is cumbersome
and error-prone since it requires at least one ATM address to be
statically configured on each host or router in the network.
Further, it is impossible to implement a diskless host to use MARS
since local configuration is required. ILMI-based Server Discovery,
hereafter referred to as "server discovery," provides a solution to
these problems.
A brief overview of the Integrated Local Management Interface (ILMI)
and the Service Registry MIB, as defined by the ATM Forum, are
provided in this memo. The reader should consult [2] for a complete
description of ILMI and this MIB, but the information contained here
is sufficient for an understanding of its use to support MARS server
discovery.
Davison Standards Track [Page 1]
RFC 2602 ILMI-Based Server Discovery for MARS June 1999
2. Integrated Local Management Interface
The Integrated Local Management Interface (ILMI) [2] provides a
mechanism for ATM-attached devices, such as hosts, routers, and ATM
switches, to transfer management information. It is based on the
Simple Network Management Protocol (SNMP), Version 1, and supports
get, get-next, set and trap operations.
The ILMI specification designates the switch side of the ATM link as
the 'network side' and the host/router side of the ATM link as the '
user side.' The Service Registry MIB, which is outlined in Section 3,
is implmented on the network side and is queried from the user side.
3. ILMI 4.0 Service Registry MIB
Server discovery utilizes the Service Registry MIB defined by the ATM
Forum in ILMI Specification Version 4.0 [2]. To support the existing
framework for IP over ATM, as embodied by ATMARP and MARS, ATM
switches must support the Service Registry MIB.
A row in the service registry table [2] is defined as:
AtmfSrvcRegEntry ::= SEQUENCE {
atmfSrvcRegPort INTEGER,
atmfSrvcRegServiceID OBJECT IDENTIFIER,
atmfSrvcRegATMAddress AtmAddress,
atmfSrvcRegAddressIndex INTEGER,
atmfSrvcRegParm1 OCTET STRING
}
The definition of each field in this structure is:
atmfSrvcRegPort - The ATM port number for which this entry
contains management information. The value of zero may be used
to indicate the ATM interface over which a management request
was received.
atmfSrvcRegServiceID - This is the service identifier that
uniquely identifies the type of service at the address
provided in the table. (See Section 3.2 for MARS OID.)
atmfSrvcRegATMAddress - This is the full address of the service.
The ATM client will use this address to establish a connection
with the service.
atmfSrvcRegAddressIndex - An arbitrary integer to differentiate
multiple rows containing different ATM addresses for the same
service on the same port.
Davison Standards Track [Page 2]
RFC 2602 ILMI-Based Server Discovery for MARS June 1999
atmfSrvcRegParm1 - An octet string whose size and meaning is
determined by the value of atmfSrvcRegServiceID.
The service registry table is indexed by atmfSrvcRegPort,
atmfSrvcRegServiceID and atmfSrvcRegAddressIndex.
3.1 Service Parameter String
A generic parameter string is defined in the service registry table,
thus allowing protocol-specific parameters to be specified. To be
consistent with [1], the parameter string for MARS shall be:
mar$pro.type 16 bits Protocol type
mar$pro.snap 40 bits Optional extension to protocol type
mar$plen 8 bits Length of protocol address
mar$addr plen octets Network address
mar$mask plen octets Network mask
Where
mar$pro.type - See [1]. (IPv4 is 0x0800, IPv6 is 0x86DD)
mar$pro.snap - See [1]. (IPv4 and IPv6 are 0)
mar$plen - Length of the protocol address.
(IPv4 is 4, IPv6 is 16)
mar$addr - Network address represented in network byte
order
mar$mask - Network mask represented in network byte order
3.2 Service Object Identifier
This OID, assigned in the ATM Forum Service Registry MIB, names MARS
within the context of server discovery.
atmfSrvcRegMARS OBJECT IDENTIFIER ::= { 1.3.6.1.4.1.353.1.5.4 }
It does not name any managed objects, rather is used to locate
appropriate rows in the service registery table.
4. MARS Client Behavior
A MARS client will access the service registry table via ILMI using
the SNMP GetNext operator to "sweep" (SNMP parlance for a linear
search) beginning with {Port = 0, ServiceID = <see Section 3.2>,
Index = 0} while holding the port number and the serviceID constant.
Davison Standards Track [Page 3]
RFC 2602 ILMI-Based Server Discovery for MARS June 1999
(Port number 0 is used within ILMI to indicate "this port.")
An MARS client with no local configuration, such as a diskless
workstation, must use the row with the lowest index value if multiple
MARS servers, possibly for multiple networks, are listed.
MARS clients that have local IP configuration must use a row that has
the appropriate IP address. For example, consider the case where an
IP router has 3 logical interfaces defined on a single physical
interface with IP addresses 1.0.0.1/8, 128.10.0.1/16 and
171.69.150.226/24. The router will sweep the service registry table
looking for rows that have atmfSrvcRegParm1 values as shown below:
Net number/mask atmfSrvcRegParm1
---------------- --------------------------------------------------
1.0.0.0/8 08 00 00 00 00 00 00 04 01 00 00 00 ff 00 00 00
128.10.0.0/16 08 00 00 00 00 00 00 04 80 0a 00 00 ff ff 00 00
171.69.150.0/24 08 00 00 00 00 00 00 04 ab 45 96 00 ff ff ff 00
When the correct atmfSrvcRegParm1 values are located, the router may
then establish an SVC to the selected server and perform the
appropriate protocol operations.
Redundant MARS servers are supported with multiple rows in the
service registry table. This list of MARS servers is ordered with the
primary MARS server having the lowest index value. The MARS client
must attempt to utilize the primary MARS server before utilizing a
secondary MARS server. Administrators must ensure that the listed
MARS servers are synchronized.
5. MARS Server Behavior
An MARS server shall be locally configured. The MARS server may
retrieve the MARS service registry data to validate the results. If
an incorrect row is retrieved the error may be flagged in a locally
significant way.
Davison Standards Track [Page 4]
RFC 2602 ILMI-Based Server Discovery for MARS June 1999
6. Relationship with PNNI Augmented Routing
An augmented version PNNI ("PNNI Augmented Routing," or PAR) [3] has
been developed by the ATM Forum. PAR can distribute data such as MARS
server addresses. Further, the ATM Forum is developing a proxy
mechanism for PAR (Proxy PAR) that would allow a UNI-attached host or
router to access PAR data without a full PAR implementation.
These mechanisms offer a promising way to manage the service registry
tables maintained on each switch in an ATM network, yet would not
require changes to the mechanism defined in this memo. Hosts and
routers can continue to utilize ILMI-based or Proxy PAR-based server
discovery and network administrators could manage the service
registry data with local configuration or via PAR and Proxy PAR.
7. Security Considerations
The server discovery mechanism is built on the ILMI managment
framework and the security embodied in that framework. Access, to
user- or network-side information is controlled by MIB design rather
than protocol security mechanisms.
The service registery MIB, the table containing information for
server discovery, is defined in [2] with read-only access. This means
that any user-side device may query the service registry, but may not
modify the service registry via ILMI. Instead, the sevice registry
table must be modified via local configuration on the ATM switch.
References
[1] Armitage, G., "Support for Multicast over UNI 3.0/3.1 based ATM
Networks", RFC 2022, November 1996.
[2] ATM Forum, "Integrated Local Management Interface (ILMI)
Specification Version 4.0," af-ilmi-0065.000, September 1996.
[3] ATM Forum, "PNNI Augmented Routing (PAR) Version 1.0," af-ra-
0104, January 1999.
Author's Address
Mike Davison
Cisco Systems
170 West Tasman Drive
San Jose, California 95134
Phone: (408) 526-4000
EMail: mike.davison@cisco.com
Davison Standards Track [Page 5]
RFC 2602 ILMI-Based Server Discovery for MARS June 1999
Full Copyright Statement
Copyright (C) The Internet Society (1999). All Rights Reserved.
This document and translations of it may be copied and furnished to
others, and derivative works that comment on or otherwise explain it
or assist in its implementation may be prepared, copied, published
and distributed, in whole or in part, without restriction of any
kind, provided that the above copyright notice and this paragraph are
included on all such copies and derivative works. However, this
document itself may not be modified in any way, such as by removing
the copyright notice or references to the Internet Society or other
Internet organizations, except as needed for the purpose of
developing Internet standards in which case the procedures for
copyrights defined in the Internet Standards process must be
followed, or as required to translate it into languages other than
English.
The limited permissions granted above are perpetual and will not be
revoked by the Internet Society or its successors or assigns.
This document and the information contained herein is provided on an
"AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Acknowledgement
Funding for the RFC Editor function is currently provided by the
Internet Society.
Davison Standards Track [Page 6]