💾 Archived View for gemini.spam.works › mirrors › textfiles › games › ARCADE › bb_44.pin captured on 2022-06-12 at 07:34:29.
⬅️ Previous capture (2020-10-31)
-=-=-=-=-=-=-
Here is the Bubble bobble wiring harness pinouts. Send corrections to:
djbarnes@eos.ncsu.edu
The 44 pin connector is as follows:
________________________________________________
|Component Side | |Solder Side |
|---------------|-------|-------|--------------|
|Ground | 1 | A |Ground |
|---------------|-------|-------|--------------|
|Video Red | 2 | B |Video Ground |
|---------------|-------|-------|--------------|
|Video Green | 3 | C |Video Blue |
|---------------|-------|-------|--------------|
|Video Sync | 4 | D |N/U |
|---------------|-------|-------|--------------|
|Speaker + | 5 | E |Speaker - |
|---------------|-------|-------|--------------|
|Key | 6 | F |Key |
|---------------|-------|-------|--------------|
|N/U | 7 | H |N/U |
|---------------|-------|-------|--------------|
|Coin Sw | 8 | J |N/U |
|---------------|-------|-------|--------------|
|Coin Meter | 9 | K |N/U |
|---------------|-------|-------|--------------|
|N/U | 10 | L |N/U |
|---------------|-------|-------|--------------|
|Service Sw | 11 | M |Slam Sw |
|---------------|-------|-------|--------------|
|1P sw | 12 | N |2P sw |
|---------------|-------|-------|--------------|
|N/U | 13 | P | |
|---------------|-------|-------|--------------|
|N/U | 14 | R | |
|---------------|-------|-------|--------------|
|1P right | 15 | S |2P right |
|---------------|-------|-------|--------------|
|1P left | 16 | T |2P left |
|---------------|-------|-------|--------------|
|N/U | 17 | U | |
|---------------|-------|-------|--------------|
|N/U | 18 | V | |
|---------------|-------|-------|--------------|
|N/U | 19 | W | |
|---------------|-------|-------|--------------|
|N/U | 20 | X | |
|---------------|-------|-------|--------------|
|Bubble Sw | 21 | Y |Bubble |
|---------------|-------|-------|--------------|
|Jump | 22 | Z |Jump |
|---------------|-------|-------|--------------|
The 36 pin connector is ground wired to 1-4, and A-D. Then wire +5V to 15-18, and S-V.
The power harness is as follows:
1 Ground
2 Ground
3 Ground
4 Ground
5 +5VDC
6 +5VDC
7 +5VDC
8 -5VDC
9 +12VDC
10 key
11 +12VDC
12 +12VDC
To use the board without a coin meter, you must insert a jumper across the points of J7
(located near IC 60, the large brown SIP IC near the G connector).