💾 Archived View for shit.cx › keyboards › h0002 › 2020-12-04-keyboard-base-mount captured on 2022-04-28 at 17:42:24. Gemini links have been rewritten to link to archived content

-=-=-=-=-=-=-

shit.cx

Keyboard Base Mount

2020-12-04T21:00

I started making a bracket for mounting the base of the keyboard.

I didn't make one of the grooves for the backplate very tight, so I brought it all the way up to offer additional support.

Cutting the rabbet (a)

Cutting the rabbet (b)

Cutting the rabbet (c)

Adding a mortise

The mortise will allow this USB port to fit.

USB port

And here it is in position.

Glue up

I made a similar piece for the front of the keyboard but I didn't take any photos or glue it in yet.

I think a rabbet from underneath may be a better technique to mount the plate.

It is easy to do
Less risk of damaging the complex parts
A groove will show if the dovetails aren't positioned just right
It allows the backplate to be removed or replaced
Much easier to apply a finish (paint/shellac) if the plate can be taken away

I will definitely do it this way for the next keyboard I make.