DIY Azeron

Created: 2023-01-10T18:53:58-06:00

Return to the Index

This card pertains to a resource available on the internet.

STL files were for-pay and appear to have been killed (probably DMCA'd.)

Bill of Materials

• 3d Printer
• STL files to print ($13)
• 3/8in silicone pads 100/$10 10c each project requires 10
• 12 micro switches $10/25 switches
• Micro controller. $7 each ( you need 1) $21
• M3 screws and nuts $9 (you will use about 1/3 of them
• Analog dpad $2 5/$10
• 22awg wire, I stripped from old cat 5/6 cable (ethernet) about 12ft
• Soldering station/flux/solder
• Micro Usb cable

Microcontroller notes

Azeron officially used the Teensy 2.0++ until they were no longer available. The clone in this instructable uses a "KeeYees Pro Micro ATmega32U4 5V 16MHz Micro USB" a.k.a. a generic Arduino Leonardo clone.

Cloned Pro Micro on Amazon