Since there was a decent bit of interest, here's a #framework #laptop update.
1/X:
I opened up the case with the provided multi-tool (T6/phillips reversible bit with a spudger at the other end). The screws on the case are captive, which is great no worries about losing one. 1 of the 5 screws wasn't perfectly aligned but posed no issues, build is solid. The spudger allows the keyboard to be lifted (top view under keyboard shown). The QR codes link to documentation (which has a lot of photos).
2/X:
The top plate is secured in place with magnets (gluing isn't the answer!) and feels very secure and still easy to remove with spudger. Only a single ribbon cable connects the top to the main board and it has plenty of play so working with it was comfortable and easy to detach and reattach.
Installing the components, RAM (which I had) and wifi-card (which I bought from frame.work) was very easy. I'd even say easier than desktop since everything is open and flat. I'll install the NVMe later.
3/X:
They supplied an advisory to put some insulating tape under the touchpad cable to prevent a potential short (similar issue to pre-2012 Macbook SATA cable, could potentially rub over time and short). I appreciated the note and put down some electrical tape, photo attached, it was #righttorepair working in the manufacturer favor. The advisory sheet also had a couple stickers on it, which was cool.
All other hardware looks good and fits well. I'm not a huge fan of the keyboard, a bit mushy.
4/4:
I have it configured with 2 USB-C ports, 1 USB-A, and 1 microSD card reader. Booting up went fine, I installed #pop_os from flash drive to microSD v90, suprisingly fast.
The BIOS (needed to disable secure boot) splash screen doesn't show FN key legend for boot device (F12) / BIOS (? I mashed a lot of FN keys), so that would be a nice touch to add.
Having WiFi issues, will investigate later. But everything else feels snappy and display looks good (3:2 ratio!!).
Happy to answer questions!