An obvious question to a 3D printing enthusiast: what is it good for? Well, I found one use.
Next to my desk and under the window is a shelf; and under the shelf was a power strip just hanging there awkwardly. Wouldn’t it be great, I thought, to clip the power strip under the shelf?
So I set about building a clip, using Tinkercad, the simple online tool:
For my first attempt I just tried to get the dimensions right, and printed a simple C shape. As you can see, it’s the right size, but doesn’t actually clip at all:
My second try was a significant increase in complexity; the shape means it now hooks onto the underneath of the shelf:
But, the part that should support the power strip doesn’t work: it the power strip just slides off. So, I added an upwards turn to hold the power strip:
The “pixel art” look was because I hadn’t figured out Tinkercad enough to make an actual incline.
Anyway, this worked! It held in place for months. But, only just: the slightest touch would dislodge it. And, the plastic gradually warped under the load:
So I recently took another try, adding some extra reinforcement to the part that warped:
Hopefully, this iteration can be the last.
It was fun to print something useful; I really enjoyed iterating on the design, and feeling smug when three iterations was enough. Even if it turned out to be not quite enough, in the end.
Incidentally, the almost-clear plastic used for these last prints is great fun, and will certainly show up in future posts.
So far today, 2024-11-25, feedback has been received 2 times. Of these, 0 were likely from bots, and 2 might have been from real people. Thank you, maybe-real people!
———
/ \ i a
| C a \ D n |
irc \ /
———